I have a Ramsey PTO Winch that I need to get a pto shaft made for. My question is does the shaft need some sort of slip yoke on it or can the...
How do you tell which tower on the distributor cap is supposed to be the number 1 tower on a Prestolite oddfire distributor? Is the distributor...
Does anyone out there have an exploded diagram of a Super Wagoneer tilt column in their FSJ service manual? I found Wagoneer tilt column for my...
I recently picked up a drive train from what I believe is a 1976 CJ5. My engine number is 908E24. Did I decode the engine number correctly?...
I am considering a 4" Hellcreek suspension lift for my 71 Jeepster. I have a question for all of you that have used these or any other 4" lift...
How is the fuel line and return line routed from the gas tank to the engine on a 71 Jeepster with a 225? Right now is has copper lines running...
I am trying to repair the carrier bearing on my front driveshaft. The bearing is loose in the mounting bracket and the driveshaft just flops...
I just bought a 1971 Jeepster and was wondering where the factory mounted the spare tire? Mine is just laying on the floor in the back. Does...
Is Spruce Tip Green a forest green or more of a teal green? I am looking at changing my color on my Jeep but I wanted to stay with an original...
What are all the differences between a new MD Juan tub and the original tub for a 1963 CJ5? I am assuming the battery cover on the cowl as well...
I have searched with no luck for a roller fairlead for my Ramsey 8000lb PTO winch for my CJ5. I figure that I will just have to fabricate one....
What year did the Dana 44 rear axle shafts switch from 10 spline to 19 spline?
I have a rebuilt F134 engine that I am starting for the first time and I can't get the oil to start circulating. I tried packing the oil pump...
Has anyone ever tried to rebuild the water pump on a F134 engine? I have seen that some of the parts suppliers sell a rebuild kit. I was wondering...
I would like to find a set of tires with the mud tread that are close in size to the original tires for the 4.5 x 16 rims. The closest size I...
Did the bench seats have fancier upholstery than the standard bucket seats? I have the original upholstery for my 1963 CJ5 bucket seats to use...
Does anyone have a source to buy the spring clips that hold the distributor cap on? I have a 1963 F-134 with a Prestolite distributor 1AY 1101...
I am installing a Felpro head gasket on my F-134 engine and I am not sure which side should face the head. One side of the gasket is solid metal...
Does anyone have any information as to what upholstery colors and fabrics were offered in 1963 for the CJ5? Also were the Tuxedo Park type...
I have the chance to pick up a 63 CJ5 that has quite a bit of rust. I have been looking at what body repair panels are available and I can't seem...
Separate names with a comma.