Sparky, I never remember Kayline having the option of a "Canvas" top. They were always vinyl-coated. Hope this is of some help to you. Glenn
Tom: You should have a T-86 Trans and you should be able to get the alignment tool from any parts store. Good Luck!! Glenn
Joel: As long as it is not around heat, I prefer the ny-locks. Good Luck!! Glenn
Marc: I think the main thing is to have oil pressure (make sure the lifters aren't rattling). 17-20 lbs. seems a little on the low side....have...
mruta: Not sure what year the Jeep is that you're looking at.....BUT....if it is 76 and later the bracket is as follows: J3196870 upper and...
The 67 w/225 should be a single lever t/c. (located on the passenger side of the transmission "hump") The trans lever should come from the middle...
Andy: I've run a P/Lok in my 27 with no major problems....over 400,000 miles on the Jeep. (Don't know how much of that is off road.....but it's...
montanajeep: as jpflat2a stated, Put a fuel pressure regulator on.....problem solved! He and I both have them. With it installed, when the float...
another difference.....if V/6 ....(66- T-86)....(71- T-14)...also 4/way flashers, radiator/grille, clutch linkage, and I'm sure more as time goes...
Wow! What a difference....somebody goofed!! Good Luck!! Glenn
Jim stated the same thing I would have stated. Glenn
If you have a hitch re-brace and cut the originals out. Install later stock rear mounted fuel tank. Good Luck! Glenn
Sounds like you need an earlier bellcrank kit, which was 7/8" instead of 1 1/8". Part number 920556 for 7/8" and 991381 for 1 1/8". Good Luck! Glenn
Jerry: Probably 10 working days.....Monday or Tuesday?? :D Glenn
duke54: To my knowledge, the bolt patterns are all the same at the engine. However there are different starters...some being supported within the...
Separate names with a comma.
