Hi, It's been awhile, I have a custom H.P. 44 rear with '71-'74' ends the wheel bearing cage (with bearings) is eating up the seals trying to...
Can't seem to find any info on what the newest sealers engine builders are using on their gaskets? It's been a long time since I've put one...
As I was reading the search for "orange" none of the hits were about wheels! Has anybody done research on the early jeep wheel color, orange???...
Did a search and found nothing (maybe wrong words???), anybody know the weights of the flat head and F head, fully dressed and ready to run??...
Some knucklehead torched off the caliper bolts and in the process blew out a section on the knuckle itself 1/4 to 1/3 of the bolthead surface,...
I'm in the process of swaping in the 3.15 low gears into the the 20 case but retaining the dbbl. offset of the 18. I don't have all the pcs. apart...
Just out of curiosity, has anyone heard of putting an old flathead 6 in a CJ, or is it just to long. I do remember someone putting some kind of...
Maybe I'm not doin this right, but I searched and found nothing??? I'm looking for info on U joints, I see some going for $10.00 and up to...
I tried for a search, didn't have any luck and I hope this is the right forum?? I was wondering who uses what brand of ring and pinion gears? I...
It's tangled in a pile of 25's, 27's, 30's, 2pt. 44's, and cent. 44's.....maybe about 25-30 of 'um!!! And now for the questions, in looking...
Has anyone played around with using thicker or thinner spring in the same pack ie.: 5/16" top with 1/4 " 2-3-4-5 leafs? I understand thicker =...
Well I didn't find much info on the subject. The question is what would be the ideal method for filling all the frame holes? Mig, Tig ?? A...
Is anybody running propane??? Do you like it and are there any drawbacks?? This may be the fuel of the future, natural gas, methane (uh oh, I'm...
Is anybody using the hydraulic throwout bearings out there??? It seems to be a great way to ease mounting all the hardware for linkage and gets...
My old '57 CJ5 frame is getting to thin and I need to replace it! I have a '74 5 frame (3" longer) and I want to strength'n it by filling holes...
My new frame ('74) to go under my '46 2A was gunna be a work of art! It was to have 6" monolinear springs with the mounts tucked up as far as...
I've got a '57 CJ5 with the offset 44 and the axle tube is 2 1/2" O.D., not the strongest! Are there any CJ offsets that are larger, 2 3/4" or 3"...
Separate names with a comma.