Hey guys been too long. I'm back working on the jeep and building bumpers. I have looked but was hoping someone could either measure or just tell...
Hey guys, I am in need of an extension to my steering column. It's not stock, but the stock shaft works with it. What I am planning to do is...
Just throwing it out there to see if any of you have done this to your Jeep to get more wheelbase and or better ride. I'm curious to know how...
Hey guys, I may have the opportunity to upgrade my axles to Scout 44's with front disks and rear drums with a Detroit tru trac in it with 4.10's...
Hey guys, Got a few ???? about an HO 4.0 I found. I have read about these engines going 200 all the way up to 400k miles so I know they are...
Anyone know if a later steering shaft will work on our Intermediates???? Thanks High5
Well, Today was the first day that my Jeep left me stranded at home. In 3.5 years, I guess that's not too bad. On to the problem....... Got...
I know how people feel about swapping Chevy engines in Jeeps and I sometimes feel the same way. That being said, I have access to a 305 out of...
Hey guys, I have had the fuel injection on for around 6 months and am very pleased with it. My question is about replacing the fuel pump. It...
Well, since it's been quiet around here I guess I'll ask more steering questions:) I adjusted the toe in last night since by my measurements I...
How tough is it to replace the joint that attaches to the steering box on the steering shaft???? It's the last thing on my list of...
Exactly what the title states. Do I just tighten them down till I can get the cotter pin through or are they supposed to be snugged down...
Thinking about upgrading my tie rod and drag link with a Rugged Ridge set up. Would like opinions on that. I think that set up uses 1 ton rod...
Are they worth it????? I have been thinking about upgrading my 4wd hardware shocks for a while and I think I'm going to pull the trigger. I...
So, as some of you might know, the last alternator I purchased to replace the stocker was bad. I installed it and the next day my battery was...
Hey guys, Installed my tach Sunday. Noticed yesterday that no matter how much throttle I give it, the tach won't go higher than 2300 RPM. I'm...
Now I know that I can take it to autozone or O'reilly's and have it tested, but I need some opinions. Came home after being gone for 5 days and...
Done some searching haven't found a good answer. Seems like the general concensus is to just use a Champion plug, but I'm guessing that is on a...
Anybody done this??? I have my EFI all done and both cables I have are way too long. I need a very short one. I looked on Summit racing, but...
Hey guys, I'm on the home stretch of my EFI install and have a problem. Well, the problem is it won't start:mad: I have fuel up to the...
Separate names with a comma.