I can convert to gas pretty easily since my unit will handle both. I just tried to cut a corner with the flux core. I was thinking about the WD-40...
This goes to all you welders out there. I just got a new MIG welder and can't seem to get it right. I can get a pretty good bead. Good penetration...
First; Semper Fi from a fellow Marine. Is the front end mounted straight? If ine fender is higher or lower then the other, you would easily be...
The only postal Jeep I've ever seen had a one pice body so I do'nt know about that one. On the steering though, it's not quite as easy as...
You could actually fabricate one yourself if you have the time and the right tools. I haven't tried it myself but I know a few people that have...
Lynn, Those sport bars are ridiculously expensive. $500 bucks for the front only? Why does that not sit well with me? Am I missing something?...
I boxed the front end of mine but only back to the engine mount. The only reason I did that was because of the power steering mod. I wanted to...
My tow bar mounts with holes also. I just drilled four holes in the stock (after market) bumper and bolted it on. The angle stays on the bumper...
Use the "hard hat" enamel from rustoleum. I painted mine with the regular paint and it chipped off with a little help from sand and ricks. The...
I fab'd up my own out of 3/8 inch plate. Unless I'm mistaken, you'll have to mount the box at an angle no matter which mount you use. That is,...
I really doubt that it's a head gasket from just sitting. My '66 sat for nearly 12 years without even being turned over. We went out there, put in...
I've got a brand new lift on mine. Can't be more than a year old and it has ALWAYS leaned to the driver's side when I'm in it. I can stand on one...
You guys are outstanding. Lynn, I really appreciate you turning me on to this site. I've been on the 4wd site for a couple years and actually left...
I think I'm misunderstanding you nickmil. The yoke attaches to the E-brake housing which is held on to the shaft by a large nut and the seal is...
Separate names with a comma.