1975 CJ5 - My front shaft is getting some slop around the splines... what options do I have for replacement? Can I buy a different year?
Ok, I put a new 401 in my 75CJ5, and the clutch engages at the very top of the pedal, and if I really get on it it will slip a bit. Do I want to...
At last, it lives! The only prob with this project was that Clevite77 sent me a rod bearing with two different sizes, and I slapped it all...
How do you identify a 401 flywheel from a 304/360, and how do you know how to orient it? I would expect something to match the offset hole on the...
I will be replacing a 304 with a 401 in a CJ5 and want to freshen up the clutch next payday. Any of you AMC wizards have a favorite vendor for...
I'm getting ready to do my first engine swap on a 1975 CJ5. Can you do a V8 swap without removing the manual trans, or is it easier to remove it?...
http://s240.photobucket.com/albums/ff67/Monteypython/?action=view¤t=DSC03659.jpg My first AMC build. Bought a 401 for the CJ5. The first...
Ok, I got my first AMC 401, and I'm ready to put it all back together with new parts. I am getting ready to hang the rods on the pistons, and I...
I'd like to buy a set of roller rockers for a new build, but since AMC heads are not studded, the studs have to be added. Has anyone had any...
I acquired a siezed 401 AMC for a few bucks and pulled the crank to check for grinds. Normally, I'm a chevy guy, and am used to grinds stamped on...
I have a 75 CJ5, and when I put the case into 4 low, it will pop out when I put some RPMs behind it. I looked unerneath at the linkage, and to...
I bought a 1975 CJ-5 earlier this March. I live in michigan and when it was snowy, the 4 wheel drive worked great. The other day I took it to a...
My 1975 jeep needs to have the wiper linkages rebuilt. I can't seem to find a supplier for 68-75, does anyone have a good link for the net on old...
Separate names with a comma.