Hi all. Looking for some opinion and or advice. I have been unsatisfied with the power of my 225. Let me say I know its not a sbc and I am...
I have a friend who wants me to help him figure out what to do with his '73 CJ5 To start with he has a 304 and stock 3 speed. As well as a...
Hi all, was out wheeling fri. and broke my front W/T Dana 30. Broke the pass. side Ujoint and then took out the inner axle ears. I cant take it...
Jeepster wheeling... PIC'S Went out yesterday thought some might like a few pics of a Jeepster in the woods. The Jeepster broke trail for...
The motor just stops making anymore power at about 3200 rpm. Is that right, or am I missing some upper rpm power.:?
I have done some searching but cant find much. I have an opportunity to get a Atlas vortec 5 cylinder drive train for free. And am trying to...
Took her out for a test run on the local forest road. Ran fine so tried some different tests. 2wheel 4 wheel ect. When in low range and...
My buddy also has the dreaded stalling issue's. And we dont know if we should go after market injection or. avenger carb. Which would you pick...
I have a buddy who wants a lower geared tcase he has a 304,t15 with a stock 20 tcase and was wanting a Atlas case. but they, A/A say it wont...
FedEx just dropped off my new Links. The rugged ridge heavyduty set for a CJ wide track. With the M38a1 TRE's and .25 inch DOM link's...
I know someone sells these anybody know who? It goes under the grill, and has notch's for the screws just cant seem to find it agian.
I have searched. I am replacing a stock heater for a heatercraft unit for a friend and cant figure out how to get the stock plenum out.... 2...
Ok this is really stupid but... I have a chance to go get a running '70 buick 350 for 75.00. And I am struggling with putting it in my Jeepster....
I discoverd something nice today. 1969 Dauntless 225 with stock rad. Everything in stock location. I really wanted a clutch fan but didnt...
I have started fabing a console with a 40 mm ammo can. I put the radio (deck) in the top of the lid at the leading edge. Basicaly under my hand. I...
[ATTACH] I am rebuilding my oil pump ,Dauntless. And I not sure about the gasket. In the picture there are 2 rectangle type holes. the one...
Ok. I have had a bad jeep day. Tuning up the 225. And its leaking oil all over my new axle.:cry: Seems the timing cover is stripped for the...
I replaced my D27 with a D30. Just got my new drive shafts. with all 1310 ujoints and .120 wall tubing. The front one is giving me trouble. I...
I seemed to be going from one new problem to the next to get to the driving my baby stage:roll: When I bought my jeep it had about 20 psi of...
Need a little help. I have never had a jeep gas tank out before so I am not positive about this. I plumbed all new lines gas and vent...
Separate names with a comma.