My 75 would roast you out after the motor warmed up. Soft top and 15 degrees or colder. Although with my glass body I did not put the cowl vent...
Brake light switch on valve is for the idiot light in the dash, not the stop lights. Don't know if you have a stock part or the on for disc set...
Impact driver, not impact wrench. Put it in the screw, push down while turning, very light tap wih a small hammer will give it more down pressure...
Sheet metal shop in my town said they would bend up and cut cut holes in stainless for around $85. Complete dash, bent edges and all. Said to...
Axle snubs/bump stops are available from a lot of places. 4 wheel drive, Quadratech, etc. May not be for your year, but should be able to make one...
Frame horns work out for you?
Bought mine from Borgeson. I called and told them what I needed and they hooked me up. 1 shaft is a D the other a spline (don't remember how many...
Registered a Bronco in Mi I bought in PA. DMV only asked for bill of sale, not title. They didn't want it. Said they didn't need it with a B.O.S....
If it's the original rad it has prob had some Bar's leak through it at some time. It could be plugged, even just from sediment. I have also bought...
Re: Spedometer cluster question. Nope, should work. Just have to remember when you glance down the where empty used to be is now full.
I tried the C-clamp and then big hammer route. Didn't work. Small hammer with light taps and plenty of white lithium grease and they went right...
I've got a set of frame horns. Yours for shipping.
You sure they belong there? Tell me the size, I've got some indestructable plastic (for lack of the correct word). I can cut a chunk of and mail...
Nice. Look inside the tub above the double layer drivers side foot well. Just in front of door openening. Black spot in first pic. Some of the...
Any friends in Georgia? Easier to register out of state with no title. They could do it and then on paper you can buy it back. Providing it has...
Separate names with a comma.
