I have a 64 cj5 5.38 gears 32x9.50x15 swampers. I have installed a modified Clifford header, Solex carb with jetting modifications and my Jeep...
Thanks! I will try to get it running tomorrow and test the trans.
I just got a 57 cj5 and I am wondering if the 3 speed trans would be a direct swap for my 64 3 speed. Both have the f134 engine. I had heard of a...
5000 is a safe number. You don't want to set it too low. If you are in a hole and have to get after it to make it through but the rev limiter is...
That is way too much oil to be going past the guides. I would have to assume there is another culprate. The compression rings have a dot on them...
Yes, dot goes up. If on wrong it scrapes and pumps oil into cylinder instead of out!
I had the 409 in my 62 chevy break a couple of rings, and it was driven hard for a while like thet. I mean 7,500 rpm every gear. Didn't really...
What did you set your piston ring end gap at. Too tight of a ring gap would cause a ring to break after heating up. Kinda sounds like what you...
If you are getting that kind of smoke, pull a plug and see which one or ones look dark. That will be the bad hole. Sorry to hear of your problems....
With that low mileage, I would not be concerned. I am sure you used cast rings. Depending on the finish of the cylinders, the rings have not been...
I believe they are jetted generically and have to be fine tuned for each engine. Mine had modifications so more adjustments were needed. A stock...
My solex was cold blooded and would run too lean so I ordered a carb kit for a pacco carb and used some of those jets, while drilling others to...
I have added a Solex type carb, header, and duel exhaust. I have a modified air intake with a paper air filter. After jetting the carb richer,...
Float got heavy or trash in the needle and seat area would be my first 2 choices. Make sure choke is opening all the way.
Separate names with a comma.
