I have a complete disc brake swap set up for sale if you are interested. Shoot me an email here if you are interested: karl.norrena@shaw.ca Karl
I have not heard many good things about the poly tanks: they leak and flex . You may want to steer clear of those. You should get a parts manual....
On the tcase rebuild. Its easy. The hardest part is setting the tolerance on the output shafts and that took me about an hour each on my first...
Could be a binding or worn out ujoint too. Grab a hold and shake each shaft. If all is tight grab a plumbers level and start measuring. angle of...
Thanks. Karl
This smells funny. '74s have a dana 20 tcase. As far as I know nobody ever made an overdirve for these. Thus I suspect that the whole setup may...
Yeah, I have never seen a 4 bike setup on this style of bike carrier either. I use this particular style bike rack and I have a fully suspended...
Not sure about how you mounted your spare, but what about using one those spare mounted bike carriers? Or you could weld a cross brace and...
While you have it out check the yoke nuts for tightness. If I recall correctly should be about 150-175 ft lbs. Are the yokes on dshaft aligned? Karl
So when you add caster do you put the fat side of the shim toward the front or the back? Pretty sure fat to the back, but I wanna confirm. Karl
You can test this. Take out the rear shaft and go for a spin. And x2 on the worn out ujoint. Karl
Dont know haw bad you wanna be stock, but I used little heim joints instead on mine. Works great. karl
I would pass on it, unless you have room for a door stop. As previously mentioned a cj-5 does not have enough room to put anything more than the...
I used a trial and error/educated approach. After some measuring I concluded that I needed anywhere between 6-8* shims. I started with the 6*...
Mine is 14.75" and I consider it nearly too short. Under full droop there is very little stroke left in the splines. When I researched my tranny...
Separate names with a comma.