I just put a Holley 4-barrel carb on my Dauntless and I'm wondering how much travel is there available in the standard linkage set-up. I don't...
Is it necessary to have the valve cover breather hooked up to the air filter assembly on the Dauntless? The reason I ask is that one valve cover...
I got a Holley heat shield for my new Holley carb and intake and I'm not sure about the order of assembly. I've found conflicting information...
Can the electronic distributor I got from Walck's, looks Chinese to me, be static timed using a VOM? It has positive and negative leads on it and...
I read in a JP magazine tech section that the Toyota Landcruiser starter would work on a flathead 4. Has anybody done this conversion without...
Is there enough difference between a dual vs single plane Offenhauser intake manifold? I have a chance to buy a used single for about half price...
Does anyone have a picture of the fuel pump heat shield thingy that holds a filter too? I have one, but can't for the life of me figure out how...
Update: Spitting back thru carb I have a 67 CJ5 with a dauntless, Rochester carb freshly rebuilt, GM HEI ignition, fenderwell headers and new...
On a 67 CJ5 with a 225, is the short section of the front drive-shaft supposed to go close to the transfer case or the front diff? The FSM...
How tight should the cable be that runs from the crossmember to the bell housing bracket? At least that is what I believe it is attached to.
Is there a way to tell if a Dana 44 rear end on a 67 has a limited slip or locker by reading the numbers on the axle? When going through a...
I just got an acient, but very cool, dwell meter tachometer combo. It has a 3 position switch labeled, "tach, dwell, points" On the face of the...
On my Dauntless I currently have a set of reproduction steel fuel lines that run from the firewall over the intake manifold and down to the fuel...
I'd like to order or buy some spare parts for the GM HEI distributor in my Dauntless. So far I've found the NAPA part number for the module to be...
What is the button head looking thing above the passenger side rear wheel on the body for?
Is it ok to run an external temp gauge as well as the temp gauge in the cluster or will it let the smoke out of something? Specifically I'm...
I have a 67 CJ5 with a Dauntless and HEI distributor, and I'm wondering if I'm doing something wrong setting the timing. The engine idles great...
With the seemingly myriad combinations for converting a 67 CJ-5 with the 225 from the Ross steering gear to power I'm lost. I have Herm's...
Separate names with a comma.