I am in Little Rock, Arkansas
Afternoon everyone, I have a 61 cj5 and I really would like an old metal hard top for it. My question to all you experts out there is what year...
I would like to buy a brand new hard top for my 61 cj5 but can not find anyone who sells them. Do they exist anywhere? Th:flag: anks for any help
DOES anybody know what the points gap is supossed to be set at on a 258 six cylinder?:flag: thanks a bunch!
good morning, I just bought a 1973 cj5 with a straight six in it, I think it is a 258 4.2 but am not sure. Does anyone know how to tell for sure...
the drains are factory to my knowledge, my 61 cj5 has the exact same ones in the same place, drivers side and passenger.
any ideas?
Just installed new clutch into my 61 134ci t-90 dana 18 cj5 everything went smoothly and lined up but the throwout bearing will not reach the...
check ebay, they have a few different gauge replacements for temp and fuel that fit into the factory cluster so you won't have to buy a whole new...
:flag: i had the same problem with mine so I decided to unbolt the bellhousing from the block and take everything out together, transmission,...
dana 18 /t-90 Can anyone tell me how much gear oil in quarts that the dana 18 and t-90 will hold together? I have to order gl-4 oil and i dont...
Can Anyone Tell Me What Weight And Brand Of Gear Oil I Should Use In My T-90 And Dana 18 From A 61 Cj5, I Live In Arkansas So It Will See Hot...
yes bolts are removed, what is pb blast? i mean this thing has no play like the bolts havent even been removed yet, should i just beat on it...
having trouble getting my flywheel off of 61 cj5 f-head 134 any ideas on what i need to do?? thanks
I have a 61 cj5 and i had to order a new wheel from quadratech, it was like $26 plus an install kit $15 and about 15 minutes of work. I hated to...
Im having trouble getting my flywheel to come off so i can have it turned, i undid all 6 nut on it but it still seems to be stuck on the shaft or...
could anyone help me with some directions on seperating these two without shafts and other stuff falling down, this is my first dance with these...
thanks for the info on the gasket, that will be very easy to make. what about this trans output shaft could anyone go into a little bit more...
I have been rebuilding a 61 cj5 with a f-head 134 and a t-90 and dana18 the transmission and tranny work great other than the fact that they leak...
Separate names with a comma.