I have done a search on the site and find a lot of exhaust information related to some of the V6's in later jeeps, but not a bunch specific to the...
I've been noticing a loss of power on my 134 recently. No knocks, pings or bad engine sounds. Rebuilt the engine about 5000 miles ago and was...
Been feeling a little wobble when turning sharp left turns and noticed a little uneven tire wear on the outside edge of the tire. Front passenger...
I rebuilt my F head about 5 thousand miles ago. Runs fine except fouls plugs and could have the carb adjusted better. I let a friend drive it...
Door hinge question How should I deal with this door hinge problem? Are there aftermarket hinges that will take care of it, or do I need to...
I am having trouble with my speedometer cable loosening at the transfer case connection. I am having difficulty getting a wrench on the nut to...
I rebuilt my F134 last year and had it running great. about two months ago I noticed a tiny spot of motor oil under the engine. so I looked for...
Went for a fantastic ride yesterday. My new rebuilt engine performed like a champ. Today went for a little ride , very modest drive, suddenly...
Following the Weber Carburetor thread which has also discussed Clifford header upgrade, I went to a local exhaust shop and asked him about how...
How difficult is it to do a valve adjustment on an F head? Any special tools required. Any tips? I have my universal service manual which I...
Hello all, Just finished up installing my (2nd) rebuilt F-134. Started it up set the timing at 5 degrees BTDC (it was dead on). I have a...
Setting up F134 today. Working on the vacuum system. I just bought a new fuel pump without the vacuum connections for the wipers because I am...
Had to replace a crankshaft recently. Bought one from a jeep repair shop in Denver. Just got ready to install it and noticed that there are some...
My F 134 is freshly rebuilt. But lacks power and is starting to make a heck of a knocking sound. Tonight I pulled the oil pan off for a look. I...
Still having trouble with my new pertronix ingniton. I'm not getting any spark. This is my second unit. First one burned up literally within...
Last Tuesday I put in my first Pertronix ignitor part 1541 for my Jeep. IAD distributor. Hooked it up to my Pertronix flamethrower 3.0 ohm...
Got my new Pertronix ignition since I've been having so much trouble with points, dwell and timing. Installed it as per instructions(pretty easy...
I've been away from the forum for a couple months because I'm so frustrated with my Jeep. Just now starting to get in the mood to work on it some...
What causes an engine to continue running for a few seconds after you shut off the ignition switch? Timing or Carburetion?
Just started my new engine. runs fast at idle with choke on. Take choke off and it slows down for a few seconds and then speeds up again. This...
Separate names with a comma.