Glad to see the forum is alive and well, I have not been on it for a long time. But in the past you folks have been a great help, for example my...
Thanks for the replies. Sounds like it's the return line (or my switch valve is bad - unlikely). My rear tank has no input for the return line...
I have a problem on my 68 cj5 that has me scratching my head. I am probably missing something simple. Perhaps someone has run into this before....
I am researching an enging swap for my jeep. I don't have time to do this my self, thus I am looking for a honest shop that does great work. I...
Thanks for all the replys. Yes, I forgot to mention that I am talking about my wagon. On the V8 comments, my understanding is that this would...
I am considering swapping my f134 for the 225. As you may guess, I have the T90, Spicer 18 setup. I understand this is a common swap done with...
Right. It's not the bulb, since the directionals work. Just looking for help/advise on what/where to look in terms of the wiring.
I did some searching in the knowledgebase, but did not find the info. I am after. 68, cj5, dual brake switches, 225. Issue: When I press...
Ring gear and starter was setup by PO. Would you know how I can check to see if things are matched up?
Every so often my starter makes a loud screaching noise when I go to start the motor. I am imagining that the starter gear is not fully engaging...
Ran across this in the service manual: Clutch section - last page (p.236 in my book): "Note: Should clutch chatter in reverse develop on a...
I did a little searching on previous clutch threads and found some good info. My question is: how tough is a clutch replacement to do yourself?...
Love the search capability! But this time this just made me more confused: Headers drop low end torque - gain in high rpm. Headers only lasting...
On mine, the driver side was not bad, but the passenger side as tough - just did'nt want to pop on, finally got it with some creative prying....
Time to replace my exhaust system. I am looking for advise/opnions on a few questions: 1. Headers - yes/no - why? 2. Mufflers - what is...
My 68 had the hopping problem for years. A few months back I replaced the motor/trans mounts. My jeep did not have the xfer case mounted, so I...
Does the T-case neutral, tranny in 3rd apply if you got an OD unit - OD in neutral?
Not sure about the consequences, but it might be tough to put on. I say that because I just replaced my motor mounts last weekend. (did I...
68 CJ5, 225, T-14 I recently removed my crossmember. I see that there is a mount hole on the bottom of the xfer case. But this has not been...
I checked with the vendor on this. They listed part # 939995 or #1370910 for the T-14. Fortuantely I had ordered both. The 1370910 part fits...
Separate names with a comma.