As I start to roll forward I get an initial thunk. I guess that would be the proper way of explaining the sound. There are no other funny noises...
My passenger side knuckle is leaking. It seems to be leaking from the seal and not the cap. I refilled it last night and it left a good size...
I recently had an issue with my T86 and purchased a rebuilt T86. When I recieved the "T86" it had T90 internals. I did some reading and found...
Just replaced the tranny with a rebuilt T90. I am having issues with getting into 1st gear. I can do it sometimes and not others. I have found...
I have removed the tranny from the 66 CJ-5 and am having issues trying to figure out what kind of tranny it is. The tranny itself has a serial...
I found my issue with not being able to stay in first gear. I took the shifter out and found some broken teeth on the sliding gear. It is...
I have a few problems here and can only hope someone can point me in the right direction. The 66 CJ5 drives but I am having problems changing...
I am about to replace my gauges and was looking at TPI Tech Guages. I was thinking of getting a mechanical Speed but was wondering if the...
Got the 66 CJ-5 out on the road. the only issue I am having is when I depress the clutch I am getting a ticking noise. It only comes about with...
I have been meaning to ask this question for awhile and I am just remembering. I re-installed my hood a month or so ago and it seems that ones...
I have the jeep running and have a new coil, points, condenser, plugs and wires. It idles fine and is at 6 degrees BTDC but when I depress the...
Got the vehicle running and am now needing to fine tune... Timing is next and I am wondering if I should time the jeep (66 CJ-5 225 V6) with the...
I am looking for pics of the proper installation of the 4wd shifter and hi/lo gear shifter. When I took it apart I did not take a picture of how...
I have my carb installed (Rochester 2G) and am having troubles keeping it running. It will start and idle fine but as soon as I give it a little...
I have made it throgh the driveshaft install and the brakes are done and good. My next dilemma is the clutch linkage. I have, as many of you...
I really appreciate all the help I have recieved for the brake lines, distributor, etc... I am trying to re-install my drive shafts. I made a...
I am going to replace all the brake lines in my vehicle and am looking for some advice as the best way to accomplish this? I have a 3 way bloch...
I am getting ready to install my distributor. I marked the spot on the distributor where the #1 plug goes. I am a little uncertain on the proper...
I just recieved 12v wiper motors and no instructions on how to install them. I know they are different than the original vacuum motors. Any...
Separate names with a comma.