so I bought a new pertronix unit, and for some reason I think its the wrong unit. My unit says to bolt on the lower ignitor plate to the...
Well so I took it out yesterday for the second time. The brakes work great now, the break lock and the brake light pressure switch work great...
I bought the engine already assembled this way so Im not sure why they built it with 225 heads. Maybe they had some sitting around with the intake.
Update the Jeepster is ready for the 1st ever test drive today. bled all the discs last night and adjusted the clutch. Now I need to drive...
okay so last night I tried to take it out for the inagural ride. I couldnt get the clutch to dissengage. I ajusted my linkage all the way in and...
I would stick with a buick v6. I found a 231/225 built engine for fairly cheap. Look for a early 231 or another 225. They rock!!!! They have...
sorry I just resized them.
Well here is a picture of my project. 67 jeepster with Cj5 front. lifted 8 inches. 73 3/4 ton chevy full width front 44 with high steer, 1 ton...
my new engine!! need help with internal information. recently purchased a 231 with 225 top end. I believe it is an odd fire, but I need to...
I run a 225 v6 and a adapted t150 with a dana18 transfer case. I need a throwout bearing for my t150. Anyone know what year /type of throwout...
Thanks for your responses. The new shackles are an inch longer than stock, they are welded together in the middle. I had some 3 degree shims I...
Ok here is the deal. I have been chasing my steering problem for months now. I have a 1958 with 4 inch lift and a front 30 that has just...
unbolted what exactly? I dont want to tear it down, I just need to pull the shafts back enough to get the carrier out. Thanks
I need to remove the axles out of my front 30 to setup my gears. What is involved in removing the axles? Thanks
nope I swapped out my dana 25 and tapered 44 with 5.38s tapered rear is gone. My dana 30 was swapped in it has 3.73s and now my new rear has...
I just put in my flanged axle with 4.88s and 11 inch drums. I love the difference from my 5.38s and 10 inch drums. Does someone know how much...
I have a chance to buy a dana 44, flanged, 30 splined, offset, with 4.88s for 400 dollars. Is this what they are going for? What is a good...
So wait I wanted to do the same thing. My 5.24 scout gears wont work in my my wagoneer 3.73 case?
information return Definitely yes the point gap is .016 the dwell angle is 30.
Hello, Ok here is the deal I decided to just wait to build my front 44 instead of rebuilding my front 27. I am using scout front and rear 44...
Separate names with a comma.