Howdy, It has been quite a while since I have been here, but I really have a question that is holding me up on the build. When rebuilding the...
I have been looking for a diagram to re-wire the jeep. It had 50+ years of jerry rigged wire so I pulled it all out. Will this (see the link...
Where/what would you get the steering bits for a SOA swap? I am am thinking about doing one.
Howdy again, I have been doing some searching for shocks and springs. So far this looks to be the best deal (see below). Does anyone know of...
I pulled the T-stat housing and there was a lot of what looked like copper corrosion. Under the T-stat there is a ton of rust in the cooling...
Again, I would like to thank everyone for their responses and advice. I have done some searching and I have found a gasket/bearing kit for my...
Hello again all, Again, I want to express my thanks for all of the help and advice. I am looking at gasket kits for the Jeep and wondered if...
Hi again, I am trying to clean up and paint the motor while it is out. I want to remove the pulley in front of the timing chain cover. I know...
After using Google to search this forum!!!!!! It looks like there were three colors for the F-head block, with black being the most common. I am...
What gauge steel should I use to box in my frame? Does anyone have any suggestions as to how best tackle this project? Best, CK
I am very sorry to be such a noob and ask so many questions. I will say that this forum has been a wonderful resource and that I really do...
I am not trying to advertise these parts, and I apologize if I have done something wrong by asking this in this forum. I just want to know the...
Hello, I got the transfer case (though I still have a nut stuck on the front yolk) and the transmission case off. I unbolted six nuts on the...
I am in the thick middle of tearing this thing apart, but I have run into a snag. What size is the nut under the PTO cover? I know that it is...
What is the round disk with groves in it? I am speaking about (sorry for no pointer) the disk that the rear drive shaft connects to. [IMG]
Well I went to the eye doc and had metal bits removed from my eyes. Not fun. What were the dimensions for stock tires on a 55? I don't want...
I was gifted a (what I believe to be a 55) Willys CJ5. The four banger runs well, but that is about all I know about it. The transmission works,...
Separate names with a comma.