Anyone know where I can get a clutch fork boot for a 1970 cj5, 225 . If not has anyone fabricated one . thanks
I went through this on my 1970. I almost threw out a good master cylinder because the rear section didn't work. On closer inspection I found that...
Please help. My 1970 cj5 , with a 225 v6 engine needs a clutch. Had one installed last year and it was a failure. It was so hard to push in...
still confused. do I need to torque each rocker arm down when both valves are in the closed position for each cylinder or do I torque the arms...
Finally its going back together after my episode with the q-tip that fell down the bolt hole into the water jacket. Had to pull the water pump to...
well, thought I was on a roll , got the head off, found the problem, had the head redone and getting ready for assembly of my 1980 amc 258. read...
On my 1970 cj I used penetrol straight out of the can, and just prayed it on . let it dry for a couple days and painted over it. Its been 3...
I have a 1980 cj5, 6 cylinder , it has been overhauled and painted by the previous owner. First off I am not sure who is the mfg as I need a...
is there only 1 air adjustment screw on a 1980 cj 6 cylinder carb, the only one I find is on its right side and does wery little when turned
I would feel way more comfortable dealing with herm as I have heard nothing but good about him. When I finally pull things apart I will see if he...
I don't know one vendor from another and came across this one on line. My brothert in law lives in NC and comes south monthly, I intended to let...
Has anyone bought from rigidsteel.com. They are a lot closer to me than Herms when it comers to shipping expense especially for the larger and...
thanks for the advice
HI I questioned broken teeth a while back as I found two little pieces in the gear box. I checked as best as I could and could not find where...
My t14 tranny works fine but wines when in second compared to 1st and 3rd. Could its prior life as a mudder where maybe 2nd gear was the gear of...
doesn't the clutch assembly bolt directly to the flywheel? If so then there should be no problem with surface contact and as long as the flywheel...
Thanks everyone
My cj has manual locking hubs on the front. If I put it in 4 wheel low range and do not lock the hubs will this mean that I am actually in low...
I am in Miami, FL. I would like to find a Co. that could either rebuild or sell me a rebuild 3 speed T14 for my 1970 cj, whatever is easier and...
I will check the cable clamp . the pedal when all the way out is tight, no play at all, on all my other vehicles there is usually 1/2" to an 1" in...
Separate names with a comma.