Kaiser Willys.com carry's all factory springs Posted via Mobile Device
Yeah, I just finished. Used herms tierod set up but the ford counterclockwise box wouldent fit between the motor mount and crossmember, this is on...
no insur. it wasent bad,melted half the harness. i worked all summer from frame up to hopefully drive this thing before cold hits. limited money....
well, i was an electrician before i was a boilermaker, thats not saying much though, forgot most of the theory, black hot, white neutral, green...
after putting body back on i wired up what i needed to start engine, had everything labled but a couple faded on me and couldent read. thru...
if i buy factory lights and upgrade to a 12volt system later i assume i just have to change bulbs right,not the entire housing. also i figure if i...
i had same prob in my 56', walt couch guided me on this one, should have batt votage on pos. side of coil and same on neg. side with the points...
134 4cyl. torque spec for output gear? also, is there a spec for the rear axle & front spindle nut? im sure there's a spec for everything but what...
Nickmill, you and walt are the best! Be lost without you Posted via Mobile Device
i have my saginaw box, going to replace the tie rods, do i use the standard cj5 tie rods then fabricate a connecting rod from the pit arm to the...
not yet, tranny is still on the bench,i should get it bolted up to the t.c. today. what is the torque spec? also, new kit had a different type nut...
i seem to have succesfully rebuilt my first tranny. only thing im concerned about is the clutch hub moving a little stiff. one synchro seemed a...
i got my differentials done and put all the upgrade stuff on but i have about a quarter inch space between the backing plate and the drum. the lip...
nice!
got a power brake set up off a wrangler and i'm wondering if i can adapt it to my cj5,ive upgraded to 11' all around and i realize i dont need...
there was virtually no metal shavings in the bottom of this thing, think i can get away with just putting this back together ?
yes, my repair will be a rebuild now. probably best to do it now. everything looks pretty good exept the slider gear,gear is pretty worn on both...
thank you guys. it will get wired while i detail it.
resto on the 56 is going very well(pics soon) however,while seperating the transfer case from the tranny i forgot to take the mainshaft nut off...
Yeah, that's the best plan I came up with too. Thanks for ur help Posted via Mobile Device
Separate names with a comma.