So I need to flat tow my 68 over 300 miles and the gear box seal's leek when the fluid is up to temp. Should i just drop the drive lines and not...
Thank you gentleman:rotflmao::rotflmao: Their's a Summit Racing just a couple miles from me they had the Stant cap in stock. The original is...
OD=2.5" [IMG] ID with tangs 2" [IMG] ID (hole size)1.75" [IMG] Fuel cap on other tank way to small"other tank is not installed in jeep" [IMG]
I'll order it from anywhere it's available even another forum member? I'll post detailed measurements with photos in the morning thanks again:p:p
One of my gas caps bounced off and I want to make sure I order the right one. I think it's a "wide mouth" cap the tangs are all the way at the...
Well I have been reading and reading rather than posting and posting:rotflmao: So far I have replaced the motor mounts,alt,volt reg,carburator...
Thank's for the feed back everyone new mounts are on the way fingers crossed. I don't think the frame is bent it seems to sit level and drives...
That's a great thought but I already tried that, it's as loose as it can be without being sloppy
Just ordered left and right side from napa for a 1976 Buick Skylark 231 v-6 I'm learningfb
No I guess i'll just order new mounts and hope it improves the issue. To hard for me to do side by side comparison with a photo.
Your right about the year and power plant! Are you saying it should be wonky and the header's just exaggerate the problem?
Ok I have exhausted the search function and would like opinions. My drive train is sitting wonky, the drivers side header "slaps" the tub and the...
Separate names with a comma.