If all else fails- Ethanol in the gas makes the needle valve stick. Its because the needle valve has a rubber tip and the alcohol in the gas...
This looked like a chewing gum wrapper, but an additive bottle seal could to the same thing. I took the tank out-- and the sensor top off,...
Tnanks-- Yes of course I have a filter between the gas tank and the fuel pump to keep junk from hurting my electric fuel pump. Originally in...
I have my 1966 with an under the seat gas tank. It is old and been repaired-- the original outlet walled off, and the drain hole fitted with an...
I converted to a Carter 4070 Electric pump and removed the machanical pump. Even a new machanical pump started to go bad in one month. This is...
excellent repair job on the piviot for the e-brake. On my D-18 the piviot bolt was a little loose, so I knerled the bolt and repressed it in...
If you cannot find manifolds-- make a set of short headers using the flanges to your existing old headers. Cut the Header pipes off ----Have...
There are about 5 or 6 different thicknesses or lengths of throw-out bearing. If you got one that is too short, the bearing will not contact the...
Exactly right-- I trimed mine and built an arch out of heavy sheet metal and bolted the new sheet metal arch to reinforce were I did the...
I put a Buick V6 in my 1966 CJ6 with Hedman Headers. I mounted the engine to the Driver's side 2 inches over from center. That way I got more...
Yea my 66 CJ6 was some kind of Forest Service or AGGIE Jeep. It was painted that Forest Service Green, with a gray windshield frame---the tail...
Yea-- I even noticed how my rubber fuel hoses get rock hard, and how the paper element in my clear gas filter turns very dark colored right a...
Separate names with a comma.