Thank you all for the advice. Much appreciated.
I have no idea about how jeeps handle at higher speeds cause my old 65 was doing good to hit 50. :) It would mostly be a daily driver on a road...
Thanks for the info guys. So ya'll think it for sure wont have the really low gears that my ol' 4 banger 65 had then? Also, is the model 20...
I'm in Missouri. I haven't heard it run yet because he said the ignition module went out in the fancy-shnancy i6 distributor I've heard about....
Hey folks!! I haven't been on here since I sold my jeep last fall. Kinda put me out of the mood thinking of someone else owning her, but oh...
I'm sorry i havent been on line for a LONG time. Just now got the message.
It has a locker and 2 blocks with a half moon lookin cut on one end. I cant really tell, the locker is in the way.
I am trying to unscrew a bunch of things left by the PO. The drivers side had no shims. The passenger side had no shims or a bearing retainer...
Looks like the spelling Gods are helping me today..R)
Re: Axle simming question Man I just can't spell today. Sorry all....
I have searched this forfum and no answer so here we go. I put the axles back in the tapered 44. Seems I only had to shim one side and it was only...
Just did Herm's kit a week ago. I would recommend it. Very easy.:D
Thank you all for very good info. I may just drive it for a bit and see what it is like. Brakes are no prob. I did a front disc conversion and...
I'm looking for opinions on a tire/wheel combo. I currently have 33-10.50's swampers and all of the tire is in the wheel well. The jeep kinda...
The gears are all ok as is the carrier bearings. $65 woth of pinion bearings later and she goes back together tonight. I have only got to drive...
I took my tux to town monady to get an inspection and license. Made it about a mile from the house and the rear end locked up. The PO apparently...
What's the verdict? Have you got it fixed?
My starter was TOAST. Someone let the smoke out of it. The armature is black and...well, TOAST!!! The landcruiser starter works perfect.
yes i would do the simple stuff 1st. If compression is good then have a look under the valve cover. If that all looks good, let it idle without...
i would be sure and do everthing i could to check the problem before diving in with both feet and tearing it apart.
Separate names with a comma.