I'm looking for another set of ubolts to hang my RC 2.5" springs on. The ubolts I got from Walcks aren't long enough only grabbing 1/3 of the...
Does anyone happen to have a Napa x-ref for these???
i'm rebuilding my D18 tcase and when cleaning it all up i noticed that 2 teeth have small bits missing.... I tried to get a pic but my camera...
I've lookd at several of the archived links here and I have found several way to mount. And wondering what some of the differencences are....
Got the day off.. sunny here in MO and working on the Jeep.. :) My F134 is missing the spring that keeps tension on the throttle linkage. The...
I'd say I'm about 90% complete on my complete re-wire on the 65 CJ5.... I got all my engine bay wired and it actually fired up! SKEW!!! The...
I have a harness kit that has a alternator exciter wire. I don't think I'm going to need it for my F134 with voltage regulator and generator,...
I have what looks to be a aftermarket speedo that has arrows at the 9 and 3 oclock position and was wondering if they are for turn signals or...
Anyone running either of these size tires? 235x75 R15 or 30x9.50 R15 I'd like to see pics and hear what everyones opinions are. I like the...
Hi all... I picked up this running 1965 CJ5 this past weekend and was looking for some opinions. It has a F-head in it that runs great so far...
I'm finding a major swing on pricing for my front D-27 ring and pinion I've got. from 150 to 300. the 150 is omix-ada and the 300 from say...
I didn't take the pictures I should have during my removal so now I have a few questions. Does the picture below look correct for 11" 1966 CJ5...
OK. I just had a shop set up the center section of my Tapered Axle D44 with a powerlok. Kinda t'd due to how much it cost and then find out my...
I just finished up putting in new 16ga floorboards into my CJ5 and new hat channel and I am now looking into trying to replace the rear fenderwell...
Anyone around the St. Louis area know of a place that can do a 1/2" radius seam roll on 16,18 or 20 ga rolled steel? Rougly 36" wide (the width...
Does anyone have any good tricks on how to remove the bushing so I can R&R them? I've used several BFHs, my air hammer etc.??? what do you guys...
Anyone on the forum have a good place to buy sheetmetal in St. Charles county just outside St. Louis? I'm taking my meyer top apart right now...
I have taken my Ross sterring box and am in the process of rebuilding it. I have a part that I seem to be having trouble finding as it was...
I've got my tub unbolted and about to go onto saw horses for some sheetmetal work and I searched for spot weld cutters and there are a lot of...
OK... I got another question as I am putting my frame on the trailer tonight to go to get sandblasted i'm looking at rebuilding the T86 and D18...
Separate names with a comma.