Can anyone tell me the size bolts I need to re-install the transfer case cover on my Dana 18? I removed the Warn Overdrive and need to re-install...
I've poked around the site a little and couldn't find the answer to a question. What year did Willys vehicles become "Jeep"? I have a 1953 M38A1...
Hey there all. I just bought a turn signal controller at a swap meet so I can finally add turn signals to my M38A1. I believe the make is...
OK, so I have this 1953 M38A1 with the 24 volt system. There are 2 batteries hooked up in series to make the 24 volts. I'm wondering if I use a...
So I just got done rebuilding the entire brake system on my 1953 M38A1 (Stock configuration) Everything new from the master cylinder to the brake...
Hello again, I've got a spare carb in my "box 'o parts" for my 1953 M38A1. It is stamped YS on one side and has 0-818 casted above the patent...
Hi all, I was wondering if anyone had a set of rebuild instructions for a Carter YS carb. I just bought a rebuild kit from Midwest Military and...
Hello all, I've been doing some digging on my 1953 M38A1 and finally scraped off enough grime to get to the Data plate mounted on the right rear...
Can anyone recommend a good source for a quality Carter YS rebuild kit? I've never rebuilt a carb before but I've been told that these are pretty...
Hey there all, I'm considering converting my gas fed Jeep to run on propane. It's the F-134 (1953). I have some contacts in the propane...
Hey there all, I just picked up a roll bar for my 1953 M38A1 since the military Jeeps didn't have them. Before cutting and welding anything,...
Hello all, I have a question about the fuel pump on my 1953 M38A1. Is there any advantages to going electric vs. original? I think mine needs a...
I can't seem to find any timing marks on my F-134. It's in a 1953 M38A1. Can anyone give me a detailed description of where to look. I guess...
So I have my '53 M38A1 with the original F134. It has 26,000 miles on it and I'm sure never rebuilt. I assume it was originally supposed to have...
Hello all, I'm looking at swapping transfer cases in my '57 CJ5 and '53 M38A1. They are both Spicer 18's. The CJ has the 29 tooth drive gear...
Hello again folks! I'm getting some free time and a little extra money set aside to get the old Willys going. It's a 1953 M38A1 I bought from a...
Hello all, I have a 1953 M38A1 that I'm working on and ran across a problem. I'm installing a Warn Overdrive and it appears the OD housing sits...
Hey there folks! I have a 1953 M38A1 that I'm fixing up to be a occasional driver here in my small town. I just bought a Warn Overdrive unit for...
Separate names with a comma.