PB Blaster first and after its running again i put Seafoam in the gas and oil to lube the upper part of the block, it will free stuck rings and...
"Christine" is alive and doing well again with its new timing gear. Its just like the movie this old jeep just refuses to die, it keeps on...
I ended up replacing my frame with a better one but before i started on it i boxed the frame with 3/8" plate from the front to the rear. It will...
The number is on the horizontal web on the left side on the top of it. (left of the pinion)
I soaked it with PB blaster and like you said with two big screwdrivers prying equally it came right off. On my last 134f i had the engine out...
How did you get the crank pulley off? Did you heat it? There's no holes for the puller. I'm just having brain fade today. I had to cut the...
About ten years ago or so I went looking for a snowblower to do my driveway. It seems my house always gets the most snow no matter what the wind...
Thanks i'll go there.
This just happened to me with my 55 cj5 jeep tractor with the 4way snowplow. Of course the white stuff will be here soon too. I need to get it...
I believe my timing gear let go on my 134f head. All of a sudden it sputtered and the exhaust got louder and it stopped running. I took off the...
The height is up to my waist on the Acorn cast iron welding tables. When i was working i had two 5'x8' tables leveled together. Right now...
I'm back again. The last time it was my 55 starter and you guys sent me to the right guy for the bendix drive that i needed. Now i can see my...
Where can i get starter brushes for my 55 willy's 134f? Or a used starter?
The best ice and snow tires are my Armstrong MET's 700-15. I can stop on and go solid ice or snow anytime/anywhere. I also have two loc rites in...
You guys had me thinking too at first. I have an orginal set of 1955 jeep locking hubs with the large brass knurled knob in the center to turn...
My first experience with lockers was a 1 ton chevy truck. It had a 11,000lb Dana 70 rear with a detroit locker and a Dana 44 with a Tru Tracker...
I have 5:38's but i was looking for the 4spd with the granny gear to have all the low end grunt she can muster with the stock 4 cylinder. You can...
I need a 4spd for an early CJ5 4cly. F head any ideas??? I'm building a jeep tractor and i boxed the frame with 3/8" plate so the 3speed just...
I like to use at least a 3/8" thick piece of steel for a guide rail when i'm torching I also hold the torch level while having an angle forward...
There should be a tag on one of the cover bolts saying the ring and pinion numbers and your '55 CJ should be 5:38:1 gears. BigBill
Separate names with a comma.