The exhaust routing seems... bad. Hanging down on the driver side. I'd look closely for other stuff out of place or poorly done based on that.
So an overdrive changes the drive ratio, just as changing gears would albeit in a less permanent fashion. Going to a lower numeric ratio to get...
You are too patient. No need for an accelerator cable to hear it start! FWIW, you are building exactly what I want. I've owned a few small...
Hope he's got a new gas cap by now... That is a sweet rig.
Four of us here. :D
I have 2 of those Caddy compressors in a box in the garage. They work well and are cheap to replace ($5 at the pic and pull). That said, I use...
I found a serviceable one on a postal jeep in a junkyard.
Stink, I didn't realize it was for sale again. Where's that spare $11k when you need it. FWIW, the ad says 55" width.
Mike - Look for pics of Tumbleweed's flattie. That just looked right to me...
x2 where did you put the drain?
It's 1/4". It'll all be boxed in when I'm done, but was considering doing the braces inside anyhow. Overkill?
Here's some shots of a bumper I'm building. Think I'm getting better with the stick welder. Having fun anyhow. :D Constructive criticism...
Seems like you'd want to extend the hitch and have the pivot point out from under the camper?
Great thread and cool project. Thanks for keeping it up. I should visit this site more often. ;)
I had a Black Diamond kit on my flattie and found it to be stiffer than I expected. My buddy has one on his 5 and his is a little too soft. He...
Could be a bad ignition switch going bad if all goes dead. I would think even with a wobbly cap the tach would still be getting a signal.
Not sure that is relavent to this discussion Ron. ;) I had rubber covers on my pedals, FWIW.
Just don't drive barefoot. Ouch.
Keep us updated on how well it works. ;)
When I converted to a 70's D30 with disks I used the dual resevior drum setup that was put on by the PO. Same size reseviors front and back. I...
Separate names with a comma.