We (dad) had an ‘85 F350 4x4, it was TTB. I believe the rear was a 10.25 Sterling. The trans could also be a T19. Do you know if it has a syncro...
Pretty cool. Did they stop making those with the advent of the intermediates? Tim
I wonder if there is a problem with the sealing surface of the crank? Do you know if the engine was rebuilt before you got it. Could it be ground...
I purchased a Ford 460 from S&J a little less than a year ago. Customer service was very good as far as the purchase experience went, especially...
I run Truetracs both front and rear in my 95 F350 and am very happy with them. Living in Alaska, I lock my hubs in when the first snow falls and...
Is this close enough? I think that era used a lot of 56 series connectors....
Here is a good video I saw a few months ago on doing a similar repair to a T19, which would be the same for T18. [MEDIA] Tim
Technically I think where the hard line is connected to rubber line, the hard line has a “bead”. There are special tools to do that but from a...
It’s some stuff I bought off of Amazon called Uxcell heat and sound insulation. I just refurbished my hard top and am getting the Jeep prepped for...
I have a Meyers hard top. It is about 33.5” from the wheel well to the top, pic included. This is at both the B & C pillar locations. The back of...
I believe I sourced mine from Napa. Tim
3M strip caulk also. Tim
Are your u-joints centered in you knuckle, that should tell you whether you have the inners fully seated or not. Tim
Their chart looks a little off in reference to model year. I think what Velopa wants is what Dutchman lists as 69-70. I think I have a set of...
I had one of those on the passenger side when I redid my d27. I used a digital angle finder to compare the driver and passenger side when the axle...
Separate names with a comma.