My floor pans are trashed, I've been rough on them and I've always told myself I will fix them when I get everything dialed in how I want it. Well...
This takes my vote with a FF.
I did a simple solution to get my rig on the road a while ago, and it is still working today. This thread might give you some ideas, I used a...
Here is the solution I came up with after a few Coors. It works good, I just don't know how long it is going to last. I couldn't find any switches...
I tried bleeding the pressure switch and that didn't work. I just picked up a philmore mini snap action switch (30-2040) at the electronics store....
It was the pressure switch. I have voltage going to it, but nothing leaving. Do these things go bad very often? Maybe an air bubble? I have it on...
My brake light set up that USE to work is as follows: Painless wiring harness, in-line brake fluid pressure switch, to rear led brake lights. I...
The actual movement or slop is in the intermediate gear. From what you described it sounds like I have the wrong spacing in between the overdrive...
So after only 160 miles on a fresh "rebuild" my Dana 18 t-case gets pretty warm. Like, I can't hold my hand on it... So obviously somethings up. I...
You might still have a problem with bump steer even after shackle reversal. The main advantage is the ride quality off-road. I like mine, but it...
I'm running 3/8" plate on all 4 and it is doing great.
Do not change speeds on a corner, go as fast as you want as long as you remember you can't stop, and braking/throttle on a corner is bad.
Separate names with a comma.