Kaiser Willys.com carry's all factory springs Posted via Mobile Device
Yeah, I just finished. Used herms tierod set up but the ford counterclockwise box wouldent fit between the motor mount and crossmember, this is on...
no insur. it wasent bad,melted half the harness. i worked all summer from frame up to hopefully drive this thing before cold hits. limited money....
well, i was an electrician before i was a boilermaker, thats not saying much though, forgot most of the theory, black hot, white neutral, green...
after putting body back on i wired up what i needed to start engine, had everything labled but a couple faded on me and couldent read. thru...
if i buy factory lights and upgrade to a 12volt system later i assume i just have to change bulbs right,not the entire housing. also i figure if i...
i had same prob in my 56', walt couch guided me on this one, should have batt votage on pos. side of coil and same on neg. side with the points...
134 4cyl. torque spec for output gear? also, is there a spec for the rear axle & front spindle nut? im sure there's a spec for everything but what...
Nickmill, you and walt are the best! Be lost without you Posted via Mobile Device
i have my saginaw box, going to replace the tie rods, do i use the standard cj5 tie rods then fabricate a connecting rod from the pit arm to the...
not yet, tranny is still on the bench,i should get it bolted up to the t.c. today. what is the torque spec? also, new kit had a different type nut...
Separate names with a comma.
