I had seen some new purchases were $300-350 online. I'm not sure if I have a driveline shop in central michigan...you think I would but nothing...
1975 CJ5 - My front shaft is getting some slop around the splines... what options do I have for replacement? Can I buy a different year?
Ok, I put a new 401 in my 75CJ5, and the clutch engages at the very top of the pedal, and if I really get on it it will slip a bit. Do I want to...
At last, it lives! The only prob with this project was that Clevite77 sent me a rod bearing with two different sizes, and I slapped it all...
LOl, after doing some CSI tricks, I found a cast number in the rust. 3197219-C. With the casting number as 12:00, the weight is a 4:30. The wieght...
How do after market flywheels work for AMC? If the weight position is a guess for each engine, how do they mass produce?
Ok, that might solve my orientation problem, but I've searched the forum for a solid answer to counter weight position for identifiation, and cant...
I have yet to put a flywheel on, the motor is on a stand, and wont fit with a flywheel...are you saying the flywheels are drilled crank specific?
Take a look at the pic, I can see where the old hole was, but how does one know where that should go? I understand you can tell the difference...
OK, I was told this came out of a 77 wagoneer. Did they run 11" too?
How do you identify a 401 flywheel from a 304/360, and how do you know how to orient it? I would expect something to match the offset hole on the...
You can do it!
I will be replacing a 304 with a 401 in a CJ5 and want to freshen up the clutch next payday. Any of you AMC wizards have a favorite vendor for...
As far as carbs go, I recommend motocraft 2 barrel. I've run several differnt 4 barrel setups on mine, and they all seem to have thier pluses and...
I'm replacing AMC 304 with AMC 401, lol.
I'm getting ready to do my first engine swap on a 1975 CJ5. Can you do a V8 swap without removing the manual trans, or is it easier to remove it?...
Painted bolts black. http://i240.photobucket.com/albums/ff67/Monteypython/DSC03683.jpg
If its HEI, pull a plug, roll it over and look for spark. no spark = bad coil, or bad coil ground. Otherwise just pull the coil wire off the top...
It turned out Hulk green. When I get paid... I was hoping for a centerforce. I wasn't going to swap until it gets a few degrees warmer in MI, so...
It sounds like fuel is lulling to one side of the carb causing floats to cut fuel, or fuel to not reach the aspiration vent. UN-Blocking the vent...
Separate names with a comma.