Well got half a block from my house, and my oil light came on. Checking the oil it was very high, thin and smelled of gas. I changed the oil and...
Are the seats for a 67-70jeepster the same as a 70 cj5? I see there are original style seat cover sets for jeepsters-Just wondering if they would...
does anyone have napa part numbers or know where to order these parts- the breather cap, hose to dry air clean box filter for a dauntless v6. its...
I was thinking of getting a pair of smittybilt lowback seats for my 69 cj5, since my seats are pretty ratty. Just wondering if anyone has tried...
The seats in my jeep are pretty bad, foam is wearing down and they are pretty torn- I need to check local upholstery shops, but just wondering if...
I need to pull out rear oil seal out of my d18 transfercase- is there an easy way to do it? I have tried using a slide hamer, and carefully prying...
I know a guy that has 5 16" rims for a 46-early 50's flat fender. I was wondering if this would be close to original rims for my 69 cj-5. Also can...
Over the winter I would like to redo my jeep seats back to how they would have looked in 1969. So wondering if anyone makes an upholstery kit. I...
Is there a difference between these two colors-1968 olive mist poly and 1969 Avocado mist poly? If anyone has jeeps either of those colors...
Just wondering if anyone has a part number for the correct temp sensor that screws into the intake manifold.
My sparton is failing to work, I had taken it apart when I got the jeep to make it work, but it was warn. I was wondering if it is possble to gut...
I ordered one through napa and it was the wrong one. looked on line and can't find one like the stock one. anyone have any idea's. If I can't find...
correct breather cap and breather line filter for a 70 v6 with the non oilbath airfilter. I am looking for the breather cap that goes on the...
Just ordered a pair of valve cover stickers. I need to know the correct placement on each valve cover. (my jeep didn't have any on the valve...
This past week my jeep started running rough or barely would run, then one morning backfired in the garage and it was just a little loud(sorry did...
it has a 10" input shaft that is 10 spline, it has a dana 20 hooked to it. What would this have been bolted to?
what are the correct exhaust manifold to exhaust pipe gasket or donut for a 69 v6. if anyone has a napa # that would be awesome. is each side...
:v6:I hooked up a ground wire and it works now, at least it went to full, which I had just fueled it up, now the real test to see if it goes down...
The ball on my clutch rod adjuster broke off, I need to find another one. what supply place would have one for a 69 w/ t14 225 v6:v6:
I have included shortcuts to different areas on my jeep, it was built in late 69 and registered as a 70 hopefully some one can tell me what color...
Separate names with a comma.