Just started my rebuilt F-head....I should have drilled a hole in the thermostat before I started because it didn't take long for the temperature...
Thanks...sounds pretty simple.
I'm almost ready to start my rebuilt F-head (61 CJ5) and have been reading all the threads I could find about this but still have a few more...
I took my dana 18 apart ('61 cj5) to clean inspect and replace oil seals/intermediate shaft/bearings etc. The output shaft bearings were in good...
After searching the threads, I found only a similar question about a dana 27 and wanted to know if the same is true for the 25 with spicer joints....
bead blasted the wheels on my '61 cj5 and am getting ready to paint them.....only question: do you paint the inside of the wheel as well? Same...
You're right...it is in the tech library - amidst the madness I must have skipped over the four lines that cover it. Thanks for the reply.
I came across an old city jeep - Appears to be a mid 70's cj5 - behind a house in an alley in Cincy. Overall the Jeep is in poor shape, however,...
You guys are scareing me with the split rim stuff - that only applies to the military bolt together rims right? or are my 15" stock rims "split?"...
I definitely have the PCV valve - as pictured above - and as outlined in the original factory service manual. So, 58WillysCJ5, what did you do...
I've searched the threads, consulted the FSM - no luck. F4-134, '61 cj-5. I've got the PCV plumbing down - from the valve T, one side to...
It's settled, I'll do the spare under the supervision of an experienced tire changer - depending on the outcome, I may finish or I may fork out...
Don't forget the bracket - http://www.earlycj5.com/forums/showthread.php?t=32235 it now appears that the bracket schematics are no longer with...
non-directional cross country - I guess we can throw a T in there, non-directional tread cross country.
I'm getting new tires (NDCC 700-15) for my '61 cj5. From what I've been told, this is a fairly simple swap that can be done at home without tire...
Billy, Thanks for the drawings...they'll make it much easier. Zach
I have those capabilities. I've been examining all the threads for the last two weeks concerning this issue. I can't seem to find the...
Does anyone have any experience with the universal alternator mounting kit A200? I've got a Delco 10SI 63amp to put into my '61 CJ5. I put the...
I use the STP lead substitute in my '61 CJ5. Seems to do just fine. I was told that it is much better for the engine to use the lead substitute...
Thanks again Glenn. Here's the sit-rep...turns out a 6 volt regulator was placed in a 12volt regulator box. Advanced auto parts has the wrong...
Separate names with a comma.