Here's a geeky one for the true Jeep pros. Anyone know the kingpin inclination angle on a D30? It's been tough to search for this one.
After a LOT of tweaking and tuning, I've got my CJ working pretty good on the trail. It's a big change from my Bronco, but I think it's going to...
I found a few threads mentioning this problem, but none of them had solutions. I want to change the pedal ratio for my hydraulic clutch. To go...
Wanted to post up a couple pics and say thanks to everyone who has answered questions since I started on this. The help has been invaluable....
For those who have a Wilwood pull-type clutch slave, where did you attach the stationary end? I built a bracket to bolt to the tranny, but the...
The body tub in my '75 is in urgent need of rebuilding, most of the floor is hacked up, the riser, the rear fenders, etc. The original seams and...
I started tearing my 5 down yesterday for an engine swap. I see that there is a filler of some sort between the fenders and the grille, and...
Finally got my 5 out for it's first "real" offroading trip and found out how bad the underbody is REALLY rusted :oops: Sorry if this question...
I recently came into enough money to do a major rebuild on my '75 CJ. It's getting 4.5" RE YJ lift springs, ARB's, 4.56's, 35's, big winch, V8 and...
Just wondering if anyone has tried using a Ford pickup power booster and master cylinder. I've got a F-350 booster and MC from a previous project...
After looking at a couple years worth of threads, I still have questions. I am putting a winch on my 75 and am not sure of how to deal with the...
It's been a while since I was into a D44. Does the carrier have to come out to remove the cross shaft roll pin? Does the ring gear need to come...
Serious question, because I haven't seen many of these. I've got a half cab hardtop that came on a Jeep I got in Wisconsin. The top and sides are...
I'm thinking of getting out of the big rock monster and back into something a little smaller and better suited to trail riding. My reading on this...
How do I remove the wiper arms from the shafts on my '75? I think the PO put them on wrong as I can't adjust the wiper blades to keep them from...
While fixing some stuff to get the 5 running, I decided to remove the battery tray to clean it up and put some paint on the firewall to slow the...
I got my 75 with a new gas tank and the skid plate laying in the tub and the original tank removed. I'm trying to install the tank and things...
Separate names with a comma.