Actually weighing out the options,I run propane on my F head right now I use my jeep for trail rides and crawling so the pane works great,but in...
Does anyone have the specs of a stock cam for the F head and L head,Duration on intake and exhaust as well as Lobe Center and Lobe seperation,and...
Has anyone actually had clifford performance to regrind them a cam for a F head,install it and see any noticable gains.
I sure would like to get my hands on one,where do these things grow or are they as illusive as the T98
I think most L heads had one groove and F's had two.
A good friend of mine just rebuilt his and one of the major factors was smoking and after the tear down the exact same thing was found,severe push...
I used a Scout T-18 case with the 18 trancase adapter,Ford 18 internals with the short input shaft and ford bearing retainer ford throwout and...
I have a ford T-18 in my 2A attached to a F head it is doable best upgrade I ever did.
Re: Anybody Put A T18 Behind An F134 Early 60's Cj5 I'm runing one right now in my 2A,F head motor,T18 with factory adaptor to run the dana 18...
Up to this point I want to thank everyone for their input,As far as Iam concerned you guy's rock,thanks again.
I'm not sure judging by the original color of the block it's the low compresion one,right now she run's pretty good when the pertronics works,but...
Well so far thanks for the info,I have a 4.3,a2.8,and a 4 cylinder out of a fiero,I like the simplisity of a 4 cylinder,I no how good the 4.3...
The tranny I'm running now is the T-18 so adaptation should be some what easier,I'm just looking for alittle more umph,but I'm sure all of use...
The iron duke or tech 4 that carries the small block chevy bell pattern
Is anyone runing the GM four cylinder motor,if so was their any noticable jump in performance.I know were talking 4 cylinders but my F head on...
Will the 5:38 gears in my 41 fit in a solid axle off-set 44
Yep, it's true both bearings removed,bring the main up out the hole and then the input,just done it.
Is anyone runing the 3.44 fist gear with a 3.15 tera low set,I've got a t18 with 6.30 first gear contiplating putting it in but no good way to...
I was runing the holley 1904 and a homemade header and had plenty of power I thought.When I switched I did notice alittle on the top end in high...
Ok,guy's take it easy on me,question currently on my 2A with a f-head Iam runing propane,works great but with it's octane rating of around 100...
Separate names with a comma.