Anyone done a flatty body on a YJ or TJ frame? Would like to see a write up or hear from someone that has done it. Thanks Keith
As I was driving back from Phoenix this morning I had a wild thought. Has anyone tried to set up a fuel injection on a L head? I was thinking...
Can someone tell me the difference in the left motor mount location on a 2a and 3a/m38? I know the #a is farther forward but do not know how...
I am trying to fit my large hole D18 to my T90 but can't seam to figure out how the t86 bearing retainer goes on. Isn't it suppose to center the...
Well I can't seem to find a battery tray for my 2a so guess I am going to have to try to fab something. Could I get one of you to measure the tray...
OK, next problem. I need a set of motor mounts. Not the rubber part but the mounts that rivet to the frame. My 2a frame doesn't have any on it and...
Hey everyone. The flathead I just got has the starter with the "push to start" solenoid mounted on it. Is there another starter that I can use...
Can anyone tell me what the difference is in a 3a motor and a M38? I found a couple flatheads I'm going to look at them tomorrow and there is one...
Just playing in my mind. What would it take to put a 4.0L in a flatty? Extend the hood area/frame ~ 10"? Like I said, just running it through my...
I have a rebuilt d18 with TeraLo gears I want to use behind a t90. The problem is the xcase is a large hole and the t90 came with a small hole...
Well I think I may have found an L head for my 2a but it is in an old military generator. Is this the same motor used in the flatfenders? Thanks...
Well I am looking at taking my 2a back to a flathead. The frame has been modified to mount a V6 and the flathead mounts are gone.. Question is,...
Hello. I have a 2a I am trying to put back to original, or close anyway.. The problem is the front frame crossmember has been removed and a piece...
Anyone done this? Is there any write ups I can check out to see what might be involved? Thanks Keith
Will it looks like I am going to get to blow the dust of my 2A after being on the back burner for 5+ years.. The frame and running gear are...
The motor in my 67 Jeepster needs a rebuild bad, blowing compression thru the valve covers. Talked to TA Performance about best way to go on it....
A friend of mine has a complete PTO winch setup off a 67 he want to get rid of. What would it be worth? Thanks Keith
OK it sounds dumb but. I just replaced the intake and carb on my 225 with a Offy and Holley 470. I'm installing a set of Holley valve covers also....
Separate names with a comma.