I've asked about this before but still hesitant. There's a R&P set on ebay that looks good but I'd like your opinion. The guy doesn't know much...
Will 6-bolt bearing hubs from a Dana 30 w/Drum brakes fit up to one with Disc brakes?
I think I'm going to give up looking for a good axle mechanic and rebuild my Dana 44 flanged axle in-house. I have all new timken bearings,...
Thanks to John for spotting this ebay item for me. Can anyone tell if this R&P is really for a Dana 30? It's clear it's a 3.73 but that's as far...
Does anyone have the orange paint code for a 70? Dash & underneath appear to be a nice orange color that's original. I think it's either Omaha...
So, has anyone used the stock e-brake handle to operate the e-brakes on an 11" rear drum upgrade? My handle works great but I'd need new cables...
Fixed links below,,, I'm upgrading to 11' rear drum brakes and front disc and I've been searching the threads to determine what I need to...
Upgrading to rear 11" drum on my D44 and front disc on a D30. I need to replace all brake lines and wondering if the stock line diameter is...
Thought I'd start my "not a restoration" thread for Elvis. I'm afraid to call it a rebuild or restoration as it's easily overwhelming. I'd...
As suggested in other threads, I'm trying to repair a nick on my dana 44 axle shaft using a speedi-sleeve. The nick is on the axle shaft where...
Just say "no" if you think this is a bad idea. I found a Dana 30 narrow track from a 81 Jeep Scrambler with 2.72 gears. It has the steering...
The output shaft of my Dana 18 has about 1/8" of play side to side. I was in the process of changing the leaking rear seal and u-joints and...
Need to remove rear driveshaft and e-brake for rebuild. At the parking brake drum, One of the four nuts that hold the drive shaft flange yoke to...
I thought the Dana 44 axle flange bolts would be easy to find. Wrong. Are these available or do I need to make them?
1970 CJ5 with a rear dana 44 flanged 30 spline axle. Disasembled/Pulled axles and found it had inner seals. Ordered new bearings and inner &...
It's been discussed on several threads but I need to rehash the question - Which limited slip is best? I'm rebuilding my Dana 44 rear w/30 Spline...
I found a nick on the axle while replacing seals and bearings on my Dana 44 flanged rear axle. The nick is directly on the axle rod where the...
Located this Timken catalog with CJ bearing & seal part numbers. CJ references start on Page 339...
I need to pull my rear dana 44 for a complete rebuild. Elvis is up on jack stands placed immediately forward of the rear axle springs. Tires,...
I came across a 1980 CJ 7 w/4 speed that's for sale as-is. No motor and been sitting about 5 years. Lot's of good parts showing but need to go...
Separate names with a comma.