I rebuilt my 2G twice but it still had a hesitation on acceleration. I changed to a good accelerator pump, no change. Then ordered a carb from...
Nice! Sometimes we just need to stop, get out our thinkin' stool, and study for awhile because the obvious is way too easy. I like your color too.
This may sound way to simple, but I had the clevis pin in the wrong hole on the clutch pedal when I put mine back. Had it in the bottom hole and...
I had the same problem with a stock Rochester and stock fuel pump. I had plugged the fuel return coming out of the stock fuel pump because I had...
Ha Ha.Too simple? My thoughts exactly. Alot of discussion over lug nuts.:p
I solved the problem of the hesitation under acceleration on my 71 CJ 225 with 2g Rochester. After replacing the accelerator pump, another good...
X2 PeteL. The slants are opposite to allow the hooks to snug it up. One of the brackets on my tailgate has the hole close to straight up and down....
X2, My 70 also had two of them. One on the frame rail near the shock tower on the drivers side and one in the line behind the master cylinder...
Just put those exact seats in my 70 CJ. Just cut a couple of short pieces of angle iron for the front of the seat and then made a small bracket...
I had one that came with my 70 cj. It was in pretty good shape, surface rust only and all of the glass was good, and had the doors with it. I...
Higher idle makes sense. I like the sound of the headers and 14" glass packs at 700 rpm tho. I'll keep messin' with it and let you all know what...
There's only one hole but I bent the rod a little to make it longer and that took the play out of the linkage. I have looked down the throat of...
Ok all you carb guys, I need to pick some brains. I just completed the frame off restoration on my 70 cj5 with the 225 dauntless and rochester...
Correction, the jumper wire goes to the temp gauge in the cluster, there is no volt meter. So do I need to do anything with the jumper wire or...
I am finishing up my restoration and am ready to wire up the fuel gauge. I have a new speedo cluster with the gauge in it, a new sender, and new...
You are correct, the switch has a 30 amp circuit breaker on it, but I went a head and fused it also. Probably not necessary but made me feel better.
I was wiring up the cj5 after my restoration today and had the same problem with a new switch. It would work perfect for 3 or 4 pulls and then pop...
Looks like the grease from e-brake may be grease slinging off of the u-joint. Could be the same on the rear wheels. Maybe from over greasing u-joints?
Didn't braze, just sandblasted the pitted rust out of the manifold and then mixed up the JB weld and spread it on the pitted area, just like...
Mine looked worse than that. Both bolts in the front were rusted and twisted off. I heated them with a torch and was able to get vise grips on...
Separate names with a comma.