Thanks for all the input. i have one more thing I was hoping someone could answer. Will Walcks P/N 910901 replace my existing splined pin and cap?...
Any info would be appreciated. At this point I am just hoping that P/N 910901 from Walck's will replace the splined pin in the picture. This jeep...
Perfect. that is the part I was looking at earlier. I have lost a little faith in what I have and was a little hesitant to buy it. Here is a...
Well, thats what the bottom bearing looks like. The brass piece in my picture is the same size as the new bearings I got and even fits in the new...
Here is pic of what I have.
Is the upper king pin on a dana 25 knuckle supposed to be splined? My lower pin is not and all my parts research says that I need part #'s 52940...
You guys are killing me.
Are you looking to part with it? I'm not in any kind of hurry and I find myself up north from time to time. John
Great, thanks for the info. I will do some digging around and place an ad in the classifieds section Thanks again, John Hicks
I'm hoping this is the correct forum for this. If not, i apologize ahead of time. Does anyone out there know of a source for the stock drawbar for...
Is it possible that the black hinges and ws frame were part of a trim package or that solid color jeep was an agri jeep or something like that? i...
Easier to read, more info, and cj5 specific. Thanks for that link. I have deleted the other from my favorites. Thanks, John
An early 58 maybe?? This is where I found the age of mine: http://www.public.asu.edu/~grover/willys/serial.html
Can a guy buy a mounting plate somewhere? I am hoping to no have to torch my good frame and weld a new mount on it. Thanks, John
Here is the pic I meant to post.
Thanks for the reply. Here is an over head of the engine while it was still running. The oil bath was in pretty bad shape so I replaced it with a...
Hey guys. I am getting ready to pull the engine and I got to looking at the existing motor mounts and the drivers side has been cut out and the PO...
This is actually a subject that I have alot of interest in. The frame on mine has had a rough life and has some poor repair jobs. It also appears...
Maxx, What size are you running and on what wheel? Any lift? Thanks.
I have searched high and low for a tire just like that. I'm still looking but the pickens ar slim. :?
Separate names with a comma.