I have a relay kit on my Electric fan now, and the sensor goes through the radiator. I think it is about a 1/16" hole. If I remember right, the...
I would love to see this as well. Any progress on the Pics????
I agree.... Got a good deal on it, picked it up for $10 and the guy let me test it on the spot...
Thanks for the input... I am glad I found this out before attempting to fish the frame. The mirror I have is a windshield mount, so I will wait...
I see what you mean, would that keep you from continuing around more to the middle of the bottom section??? Does the Arm actually block the path???
I am replacing my Rearview mirror with one that has AutoDimming and Map lights and was wandering if the windshield frame is open enough to fish...
That would be very nice to have... Please E-Mail it to Casey.S.Hurt@usps.gov Thank, Casey
Went out and worked on the Jeep for a little this morning, went down to the salvage yard and got a Harmonic Balancer from a Javelin w/ a 258. Got...
It runs right in the middle of the water temp gauge.... I have looked again and there is not balancer, just a pulley.... Found this very odd, I...
I agree, the PO did some wierd things... This was his first "Project Car" he built race bikes and traded one for this. The Carb is way too much,...
I have found these twice. Once at a local Ma and Pa shop here in town. Second was at a doitbest hardware.
Here is the info on the Cam I have....
He was running the high octance for "More Power" according to him. He used the jeep for offroad only, he trailered it to places to 4 wheel. I want...
Man, thanks for all the great info. I will try re-timing altough from the last post I will check the timing after the engine has cooled first. To...
No Clue on exact timing.... When the engine rebuild was done, the tab for the timing marks was not put back on. I have been timing using vacuum. I...
I just finished timing my 258 a couple of days ago, since it was hard to keep idling and pinging. I got it tuned back where it should be and it...
I went with the Painless kit on mine... No Soldering required, however I did opt to solder some of the harder to reach connections (reverse light...
Can you use those to retain the 5x5 1/2 bolt pattern???? Or does that change it to a 6 bolt.
I just made my own out of PVC... I flared the end and used a torch to heat it up while I rolled it around until it became as flexible as a noodle....
Boyink, Lemme know what you want for these.... You can pm me at Churt1@-nospam-cox.net (just remove the -nospam-).
Separate names with a comma.