Thanks for all the info guys, it will come in very handy, thanks again.
The Detroit diesel that I had in my trucks is a GM engine as well as the Buick that we have in the jeeps. The Detroit diesel, Alpine Green, is a...
I have the 225 Dauntless, I have tried searching but did not find much, maybe just me. So where do you find a rebuild kit for the 225 Buick????...
go to your local parts store and do it right, do not want to use any old bolt and or nut combo, unless you take them to a good hardware store and...
I have tried to find some posts on this but not much luck though I am sure it has been covered. I have been thinking about putting a s-10 tilt...
OK yes it has the 373 gears and it will be a pavement pounder. I have been afraid to say that because of ridicule, after all it is a jeep not a...
Ok ya the transfer is an 18, the numbers on the rearend are C-32192-1 cant find the 44 numbers anywhere, maybe easier to find when I tear it...
I dont know what I would achieve, just asking questions to see what way to go. Think I would like to leave the v6 in it, it has a 3 speed in it...
Is this the right place to post??? So I traded an old truck and got this 67 cj 5. It is all stock with the excepyion of some new superlift...
So in my travels you can lube or not lube do not think it will make much of a difference. For example if it is raining out the springs are wet,...
Yes I am talking to myself and guess I will leave it stock for now and if I want to change in the future after the build is done then I will get...
So should I just leave the stock running gear in it, this will most likley be a garage queen for the most part, just not used to that closed...
As stated earlier there has been alot of discussion about this in the future so I just need to go search it. But since this will be a garage queen...
Thanks guy that was alot of good info, will not be getting those axles, thanks
or as far as that goes will a 30 and 35 from a cherokee fit as well, do I just need to measure and see???
Will the axles from a 1983 cj 7 fit in a 1967 cj5 fit with no problems? Thanks for any info...
not sure how they are made now but look for springs that have a tapered end on the shorter leafs vereses a square end used to be that the square...
As far as pulling springs out you can pull as many as you want out to get the ride you want, yes this is the wallett friendly version but it...
Thanks a ton, so not to be ignorent but this will prob be a pavement pounder most of the time, is there a reason for going to a twin stick or is...
So I am new to this forum and new to jeeps,again after 20 years since the last one, seen lots of great info here. I did some research on my 67 cj5...
Separate names with a comma.