I have searched and found the specs for the brackets that attach to the floor of the body tub but I haven't found anything as to the brackets that...
Does anyone have have the measurements for the rear seat brackets?
Does anyone know what spare tire carrier will fit my 74? The original body was replaced by the PO with an unknown year metal body bought from a...
Ahh....what a great idea....can't see the forest cause of the trees....Thanks
Does anyone have a source for the dhead bolt that attaches from the bellhousing of a T18 thru to the trans? Or a recommendation for modifiying an...
Hmmm. Not looking forward to pulling that heavy mess out again. I will go with a CV drive shaft, not sure what size lift to go with at this...
While checking the adjustment on my clutch linkage I found that the pivot ball mount on the bellhousing (74 CJ5-258/t18/d20) was broken. I must...
Two lines from the tank run to the liquid check valve (bottom ports). The top port on the LCV runs to one of the ports on the canister. One of...
I am in the process of installing a T-18 in my 74. I had to go with a different trans mount (R&P 4wd parts) and drilled the stabilizer mount...
I think I have it all together...it is a Jeep T18 w/ a input shaft from a 304/T150 combo. The Bellhousing is correct for my application per the...
Tim, (and fred) thanks for your help. No adaptor plate between the bellhousing and the trans I will call a vendor with the pilot/diameter and...
Tim, the T18 came with supposedly the correct bellhousing. The PO said he had set it up for his CJ. The trans/bellhousing has been...
I double checked, it is a Jeep T18 but might be out of a FSJ. The input shaft stick out is about 6 1/2" so I think I have the right components....
I believe that I have the correct input shaft on the trans, the spline count matches the T14. Guy I bought the T18 from said he installed the...
My T14 to T18 swap is being held up for a bit. The original (1974) T14 was mounted to the 1978 engine. Do I have the correct pilot bearing or do...
Lynn, thanks for the input. I was looking at the original mount and thinking about doing something like that.
Thanks Nickmil, I figured I'd have to move the crossmember and there are a lot of possible mounting holes in it now. More fun for the coming...
Im just about ready to install the T18 as a replacement for the T14 in my 74 and have run into a snag. The stock trans mount for the T14 has a...
Thanks everyone. If it was originally mated to a T-14 the gears are compatible with a T-18 from what I can decipher on the Novak website. My...
Hello all, new to the site. Im looking at buying a model 20 t/case and Im not sure what it is. Its a Dana 20 w/ id tag numbers 300596-95 and...
Separate names with a comma.