Getting ready to reassemble the Dana 18. When I pulled it apart I found that the set screw on the front wheel drive fork is not the stock screw...
Starting my rebuild of the Dana 18. Was getting ready to remove the output shaft bush but before doing so wanted to see how snug the new bushing...
Finally getting around to mating my SM420 to the Dana 18. Any preferences on whose adapter to go with and why? Thanks! Pat
Now that I've got mid 60s corvette ram head style manifolds coming, on to the next exhaust matter at hand; mufflers or glass packs? Currently I've...
Which would you choose? 63CJ5 283 Chevy, D18, Warm OD, Dana 27/44, 33s. It currently has, I believe, an M21 that the 283 was matched with when it...
I currently have long tube headers on my 283 in my 63 CJ5. They're to the point where no matter what I try I cannot get them to stop leaking....
I know this is more of a Chevy question than a CJ question, but since my CJ has a Chevy in it.. Looking to replace the heads on my 283....
Picked it up today. New tube, new yoke on the axle side, and two new u joints. A little pricey I thought at just under $200, but it's done and...
Finally getting around to replacing the rear driveline I twisted in to pieces a few months back. Any quick advice on how to measure it up for...
So who likes their Skyjacker Soft Ride 4" lift? My rear fenders can't take it anymore. The 33 x 12.5 have been dealin' them a beating and I...
Replacing the 3rd stop light switch in 2 years. Anybody else having this issue?
How far from the top should the brake fluid level be on a single res. MC?
Well I'm finally getttin' ready to tear into the SM420 that was sittin' out back my uncle's house for years. My transmission rebuild buddy is...
So I've decided on the Aussie locker and was trying to figure out how many splines on my axles. I looked through the tech section where it says...
Anybody broken an Aussie locker yet? It's time to install a locker and I kinda want to see how these a Aussies have been workin' out for you guys....
I'm blowing oil out the dipstick tube of my '67 283. The rubber seal/groummet is gone, but the metal cup on the stick is still there. I realize...
Anybody running a 4" suspension lift? Happy with it? I'm still bending in the right rear fender with the 33". The springs are sagging and I've...
Plan on swapping out my M21 for a SM420 as soon as I can scrounge up the $$$ for the Novak adapter. Anybody know if I'll need to lengthen/shorten...
Since I put the 33" on my right rear fender is taking a beating. I keep bottoming out and push the fender in behind the wheel. I think I got 2.5"...
Went out this last weekend for the first time with the new wheels and tires. Had a great time in the Mojave desert trailin' and climbing hills....
Separate names with a comma.