Anyone know where I can get a clutch fork boot for a 1970 cj5, 225 . If not has anyone fabricated one . thanks
Please help. My 1970 cj5 , with a 225 v6 engine needs a clutch. Had one installed last year and it was a failure. It was so hard to push in...
Finally its going back together after my episode with the q-tip that fell down the bolt hole into the water jacket. Had to pull the water pump to...
well, thought I was on a roll , got the head off, found the problem, had the head redone and getting ready for assembly of my 1980 amc 258. read...
I have a 1980 cj5, 6 cylinder , it has been overhauled and painted by the previous owner. First off I am not sure who is the mfg as I need a...
is there only 1 air adjustment screw on a 1980 cj 6 cylinder carb, the only one I find is on its right side and does wery little when turned
Has anyone bought from rigidsteel.com. They are a lot closer to me than Herms when it comers to shipping expense especially for the larger and...
My t14 tranny works fine but wines when in second compared to 1st and 3rd. Could its prior life as a mudder where maybe 2nd gear was the gear of...
My cj has manual locking hubs on the front. If I put it in 4 wheel low range and do not lock the hubs will this mean that I am actually in low...
I am in Miami, FL. I would like to find a Co. that could either rebuild or sell me a rebuild 3 speed T14 for my 1970 cj, whatever is easier and...
1970 dauntless v6 clutch problems. once the beast warms up and is driven for an hour or so the clutch doesn't completely desingage and it grinds...
Hi All I do not have the option of low range in 2 wheel drive but I do have locking hubs. Can I run it safely in 4 wheel low with the hubs...
Well I thought I really did good in replacing my front shackles with a new heavy duty set, Got the inner sleeve and rubber insert out using a...
thanks to the tech section posts on how to remove stubborn shackle bushings today's project was a complete success. after hammering on them for 5...
Will only one broken tooth ruin my jeeps smile. While changing the trans fluid I found a 1"x3/8" piece of a gear. Everything runs, shifts and...
on inspection of the gear lube in the 3 speed trans I found evidence of water in the gunk that had settled by the drain port. How can I flush the...
The 2 lb residual pressure valve in my front disc brakes works too good. It holds the brakes on. the 10 lb valve for the rear drums is fine....
Well I am almost there with my brake job. Found a master cylinder that is a perfect match but I have a question. I have front disc brakes, as I...
ready to reinstall the front hubs on my dana30. There are two washers one larger than the other. Which one goes on first?
just filled the steering box with lubricant and it started to leak out where the horn wire comes out of the unit, could I have overfilled it or is...
Separate names with a comma.