after putting body back on i wired up what i needed to start engine, had everything labled but a couple faded on me and couldent read. thru...
if i buy factory lights and upgrade to a 12volt system later i assume i just have to change bulbs right,not the entire housing. also i figure if i...
134 4cyl. torque spec for output gear? also, is there a spec for the rear axle & front spindle nut? im sure there's a spec for everything but what...
i have my saginaw box, going to replace the tie rods, do i use the standard cj5 tie rods then fabricate a connecting rod from the pit arm to the...
i seem to have succesfully rebuilt my first tranny. only thing im concerned about is the clutch hub moving a little stiff. one synchro seemed a...
i got my differentials done and put all the upgrade stuff on but i have about a quarter inch space between the backing plate and the drum. the lip...
got a power brake set up off a wrangler and i'm wondering if i can adapt it to my cj5,ive upgraded to 11' all around and i realize i dont need...
yes, my repair will be a rebuild now. probably best to do it now. everything looks pretty good exept the slider gear,gear is pretty worn on both...
resto on the 56 is going very well(pics soon) however,while seperating the transfer case from the tranny i forgot to take the mainshaft nut off...
iv'e got my 30 front axle,now i have to put 5:38 gears in it. can i use the ones out of the 27 or do i have to get new ones. this is gonna get...
i found two axle assembly's, narrow track off a 79 cj5. it has the disc set up i would like to use but its 4" wider roughly. can i adapt these to...
want to upgrade the brakes on my 56 cj5. what are my options? can i put discs on the front of this without spending a grand? will 11" drums be...
o.k., i've decided after today that i'm definitly converting to 12 volt.i'll keep all the 6 volt stuff if i ever decide to sell it as original but...
where can i find an engine manual and wiring diagram for my 56'. also,im not going to assume that this is all stock.how do i make sure what...
like i said in previous thread,want to keep it close to stock, what are your thoughts on the voltage system. seems to me that 12 volt will be alot...
i would like to keep my project as close to factory as i can but i would like the jeep to be a little more driver friendly. if i put disc brakes...
Separate names with a comma.