True Lockers in a front axle on pavement are not going to turn worth a darn. When you make a turn the outside wheel has to travel farther than...
I just scored a M38 tub, a hood, tailgate, fenders, and windshield frame today that I'm going to use on my 2A project. I have to decide now how I...
I hate to say but if you want a 4.0 Jeep it will be easier just to buy a YJ wrangler with one in it! If you love round headlights put one in a...
33K miles as a plow could be considered over 100k driving miles... just think of the strain on the drive train, engine, and brakes, frame etc.
Well I replaced the pump and it was pumping but there was no fuel in the carb.. I suspected the needle was stuck so I pulled the carb apart. Yup...
Use a grade 8 bolt and nut and that will hold up better than what you have. Tighten your puller bolt and then smack it... tighten then smack......
That part number looks like the same number of the omix pump I had. I'm planning on installing the Airtex pump tomorrow.
Check your plugs and wires too... just cause they are new doesn't mean they are in working order. I had a miss I couldn't figure out until I...
I have a Fisher plow blade that is sitting in western mass. I have no need for it in Florida! It came off my FC-150. If anyone needs it let me...
I replaced the fuel pump on my girlfriends 2A with one from Jeep Doc and it would not prime for anything... I took it apart and I found it had NO...
OK It seems my cheap Omix fuel pump has failed. It's been on there for a few years but has almost no miles on it. It won't even pump let alone...
My Omix fuel pump diaphragm has failed miserably. I'm guessing it's not ethanol compliant since it is leaking and no longer pumps. Pretty...
On the subject of fuel pumps. I replaced mine a few years ago with one from Jeep doc. I tried the start the jeep a few weeks ago and the fuel...
I had a tow behind compressor that had a Ford 302 in it. One side (four cylinders) ran while the other side had a special head on it with reed...
Separate names with a comma.
