I finished the title paperwork today and now I just have to wait for the title in the mail. I am going to photograph the parts and then find...
I actually parted out 2 other intermediate CJ6s when I was collecting parts for this one. I would prefer to find a buyer for it all at once but I...
Ok I will add some pictures of the big parts when I get a chance. I was hesitant to post them as I though the admins would think it was a for sale...
I would appreciate some help in determining a reasonable value for what I have before I list it for sale (this is not a for sale ad and it is not...
Mine is the later style same as the one shown in the pic above. I would of kept it but it blocked the upper grease fitting on my aftermarket...
Cool. Thanks
I had to remove the factory drawbar setup from the 75 frame I used for my build because of my HD greasable shackles. I want to put it up for sale...
Ok so it sounds like 1" long should do given 1/4" thick isolators. All the bracket holes are sized for 3/8" bolts. Thanks for the info.
Ok so just s 3/8" nut, bolt, and and washers for the front and longer 3/8" bolts, nuts, washers, and rubber isolators for each rear bracket. That...
Ok cool. So just a nut, bolt, and washers. Thats good news. Thanks
I have the brackets. I just need the hardware that that goes with them. You can see a threaded part sticking out in the picture. Thats what I am...
I am reassembling my frame brackets and I just realized that none of the donor Jeeps had the hardware that goes in the front gas tank mount (the S...
Separate names with a comma.
