1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by BC3Jeep

  1. BC3Jeep
    Post

    Binding problem with Trany and t-case. (T-90)

    Is it possible that there is a distortion on the face of the new Tranny that is causing a bind at the very end of torquing??? Is it just one bolt...
    Post by: BC3Jeep, Mar 7, 2012 in forum: Flat Fender Tech
  2. BC3Jeep
    Post

    Charging Issue

    I suspect three things.......Alternator Belt Tension....... Belt Condition.....Belt Engagement. If belt is too loose..... no charge...... if you...
    Post by: BC3Jeep, Jan 10, 2012 in forum: Intermediate CJ-5/6/7/8
  3. BC3Jeep
    Post

    Alternator Question

    Fresh paint... bad for grounds.......make sure metal to metal contact is being made with the base and the fender.
    Post by: BC3Jeep, Jan 10, 2012 in forum: Intermediate CJ-5/6/7/8
  4. BC3Jeep
    Post

    clutch issues

    and.... how much "free play" is in pedal-cable-throw out arm" while cool......versus while warm???? Could be something is warming up and...
    Post by: BC3Jeep, Dec 18, 2011 in forum: Early CJ5 and CJ6 Tech
  5. BC3Jeep
    Post

    Heater core soldering

    I would X2 on taking it to a radiator shop... leave the professional work to the professionals....... the $$$$ will be well spent with a HIGH...
    Post by: BC3Jeep, Dec 12, 2011 in forum: Early CJ5 and CJ6 Tech
  6. BC3Jeep
    Post

    Where to find vinyl (or other) cover material for tailgate chains

    X2 on the bicycle tubes......last a LONG time.....
    Post by: BC3Jeep, Dec 3, 2011 in forum: Early CJ5 and CJ6 Tech
  7. BC3Jeep
    Post

    Extra hood latches?

    If you are serious about this worry..... add some chain to the INSIDE of the hood with a padlock. I have done this to several of my vehicles over...
    Post by: BC3Jeep, Oct 21, 2011 in forum: Early CJ5 and CJ6 Tech
  8. BC3Jeep
    Post

    I hope it isn't too bad...

    That kind of smoke is usually nothing more than valve guide leakage (oil leaking past the valve guides in the head). If you take the head off to...
    Post by: BC3Jeep, Sep 28, 2011 in forum: Early CJ5 and CJ6 Tech
  9. BC3Jeep
    Post

    It's Alive! (with an issue)

    ^ is right about grounds.....Another possibility..... is there a relay in your headlight circuit that may be missing/bad????
    Post by: BC3Jeep, Sep 28, 2011 in forum: Intermediate CJ-5/6/7/8
  10. BC3Jeep
    Post

    Cylinder #3 not firing

    Would ALSO try the "stick a screwdriver in the plug boot and see if it sparks to ground" trick before going too much further. If it sparks to...
    Post by: BC3Jeep, Sep 17, 2011 in forum: Early CJ5 and CJ6 Tech
  11. BC3Jeep
    Post

    Engine problems...again...

    and NEVER be friends with THIS guy......
    Post by: BC3Jeep, Aug 30, 2011 in forum: Flat Fender Tech
  12. BC3Jeep
    Post

    Any wiring geniuses

    If it was me..... I would disco the Haz switch and see if problem remains..... if not......suspect switch...... if so.....suspect wiring.....
    Post by: BC3Jeep, Aug 26, 2011 in forum: Intermediate CJ-5/6/7/8
  13. BC3Jeep
    Post

    After market heater blower motor wiring

    Measure the amount of current that the blower draws and find a very low resistance high wattage resistor to match. Put this resistor in series...
    Post by: BC3Jeep, Jun 12, 2011 in forum: Intermediate CJ-5/6/7/8
  14. BC3Jeep
    Post

    Drown out today..

    I read an article recently about cutting the bottoms out of plastic containers and placing them around sensitive components and sealing with...
    Post by: BC3Jeep, Jun 7, 2011 in forum: Intermediate CJ-5/6/7/8
  15. BC3Jeep
    Post

    Master Cylinder ???

    Did you bleed the Master Cylinder before bleeding the individual brake lines? Skipping this step has caused many a brake system to feel "mushy"...
    Post by: BC3Jeep, May 31, 2011 in forum: Flat Fender Tech
New Posts