Use the rear brake setup. Get a pull up handle assembly from the junk yard, and put it between the seats.
First off, get a good helmet--------the newer electronic ones with the auto darkening are great units. It may turn out that with a good helmet...
These folks are where I would start searching---unless someone comes up with a Jeep specific vendor who has them. http://www.fastenal.com/web/home
Yep, beat me to it.
Did you do the rebuild yourself?? I suspect not by the nature of your question. Maybe you should take it to the shop that did the rebuild ??? As...
Permission granted :D You have already made a number of non stock modifications----------go for the V6.
Do the ones you bought have a metal sleeve around them???
Ted, you must post your photos to a site that specializes in hosting images. I use Picasa, but there are a lot of them out there. Once you have...
Ted, welcome to Early CJ 5 from Cameron Park :D Try reading this for photo help, it is from another forum, but same method applies here....
Did you notice any scuff marks in the old rope seal-----outer surface of the top half??
How was the old seal installed when you pulled the cap off?? Did you have any issues getting the old seal out?
But Howard, I did tell you that about 15 posts ago..........just a slightly different terminology.
I agree that it is most likely leaning out in transition ----------- BUT, that alone will not ignite the fuel/air mixture in the manifold.
Here is my build thread with lots of photos of the tranny and adapter mentioned above, you may find something interesting/helpful in there....
Old trick I learned many years ago, take off the air cleaner, run the engine at 1500 or so RPM, and slowly pour a cup or two of water into the...
Separate names with a comma.