thankyou for the help. Called novak today and ordered the right bushing and bearing and they threw in gaskets for free.
what site are you refering to. What does irrc stand for
I purchased a used adaptor for a dana 18/20. I thought that my transfer case was had a 4 inch bore because of the 10 spline input gear. But found...
I have a dana 30 with disc brakes that I got from a junk yard about 2 years ago. I am almost done with everything for my swap. The question I...
The PO did it to mine, it looks like he just took a park brake handle off of a junked passanger car and mounted it between the seats. Mine has the...
my 1970 came with one and 3.73. when I went to regear it about half of the clutch pack was bad. But I had to buy a new carrier to go up to 4.10.
When I regeared my dana 30 from 3.73 to 4.10 I didnot need to get a new carrier if that helps.:)
I am installing a rear tank with skid plate is there something that goes between the tank and the skid plate? Like a rubber pad or does the tank...
Re: Dana 44 Axel Vents They are easly replaced and do not cost much. You can get them at any auto parts store.
could you have a stuck choke? That would let it idle but not let it drive. (like when you try to warm up a small gas motor on a cold morning)
I am using a flywheel from a 231. If I rebuild my motor I will have the machine shop balance everything together, If I go with the long block I...
I am getting ready to rebuild my 79 buick 231 engine. But I have been looking at buying one of these reman engines. The one that I am looking at...
Separate names with a comma.