I am about to do a springover with the lift i have now which will give me about 11 inches. I called toms and asked how much it costs to make a...
Well that stinks I wonder where I can find a seal like that because my axles go under water a lot and those were very helpful.
Ya i need one of those too because there was no seal at all on the outer to keep crud out of the shaft and I was wondering if that one would work?
so what about the link i posted? http://www.sealsit.com/jeepaxle.asp
I had replaced all my brake lines and was starting on replacing the axle seals and once I got the front passenger seal out and tried to put the...
Actually the seat mounts on my jeep are about a half of an inch to narrow for the sliders on my new seats to bolt on so I'm just going to weld...
What console do you have? I was looking at this bestop http://accessory-center.com/prod.plx/30/3867/885?f1=JEEP&f4=1975&f2=CJ-5 But I also bought...
Same here guys. Oh and loving that bumper sticker springer.
That also sounds like a fun idea:twisted:
that bumper piece is pretty bent up so im just going to take it off but the ramsey i have mounts directly to that plate but the plate is just a...
I think i've figured it out. I found this in the back of the garage. [IMG]
Did you have to buy the plate specially for your year jeep?
I'm looking for an aftermarket front bumper with winch mount for my 75 but I can't come up with anything. I don't really want to fab one because...
Separate names with a comma.